Results 181 to 190 of about 6,236 (302)

Numerical analysis of the effects of corrosion on the punching shear capacity of reinforced concrete flat slabs with openings

Structural Concrete, EarlyView.
Abstract The reinforcement corrosion is one of the main degradation mechanisms in reinforced concrete structures. Its effects can harm structural elements by reducing mechanical capacity, mainly due to diminished reinforcement properties and expansive reactions within the concrete.
Vinícius D'Almeida Rodrigues Ramos, Leandro Mouta Trautwein, António Pinho Ramos, Elyson Andrew Pozo Liberati   +3 more
wiley   +1 more source

Loop closure grasping: Topological transformations enable strong, gentle, and versatile grasps. [PDF]

Sci Adv
Barhydt K, Osele OG, Kodali S, du Pasquier C, Hartquist CM, Asada HH, Okamura AM.   +6 more
europepmc   +1 more source

Bayesian Flexural Rigidity Identification of Small Wind Turbine Blades Using Unscented Kalman Filter

Saeid Fadaei, Esmaeil Ghorbani, Fred F. Afagh, Robert Langlois   +3 more
openalex   +1 more source

Evaluation of prestress losses in concrete beams using destructive and non‐destructive methods

Structural Concrete, EarlyView.
Abstract Over the past few decades, prestressing techniques have become essential in the construction of key structures, infrastructure, and bridges. The serviceability and safety of prestressed concrete (PC) elements are closely tied to the effectiveness of the prestressing process.
A. N. Consiglio, G. Muciaccia, G. Rosati
wiley   +1 more source

Experimental investigation on post‐installed anchorages with cast‐in anchor reinforcement under tension loading

Structural Concrete, EarlyView.
Abstract Anchors are used to connect different structural and non‐structural components to reinforced concrete structures. Anchorages when subjected to tension loading might fail in different failure modes, with concrete cone breakout (CCB) being one of the most common.
Deepak Suthar, Akanshu Sharma, Roberto Piccinin, Boglarka Bokor   +3 more
wiley   +1 more source

Mechanics of Epoxy Nanocomposites: A Study on the Synergy of the Reinforcements. [PDF]

ACS Omega
Pir İ, Tüfekci M, Acarer Arat S, Tüfekci E.   +3 more
europepmc   +1 more source

Low bending rigidity and large Young's modulus drive strong flexural phonon renormalization in two-dimensional monolayers

Navaneetha K. Ravichandran
openalex   +1 more source

On the Measurement of Structural Elasticity of Fingernail and Its Flexural Rigidity

, 2017
Daiki Taniguchi, Hironori Tohmyoh
openalex   +1 more source

Evaluations of the effectiveness of the near‐surface mounted steel materials in strengthening short RC wall‐like columns with openings

Structural Concrete, EarlyView.
Abstract In practice, reinforced concrete (RC) wall‐like columns often have openings to facilitate building services, which creates stress concentrations around the opening, resulting in the weakening of their load‐carrying capacity. This study proposes innovative strengthening methods using near‐surface mounted (NSM) incorporating steel materials to ...
Ahmed Hamoda, Mizan Ahmed, Mohamed Ghalla, Ahmad G. Saad, Aref A. Abadel   +4 more
wiley   +1 more source

Performance enhancement of reinforced concrete columns using stainless steel and galvanized steel plates: Experimental and numerical investigation

Structural Concrete, EarlyView.
Abstract This study introduces an innovative approach to strengthening defected reinforced concrete (RC) columns using externally bonded stainless steel and galvanized steel plates. Unlike conventional strengthening methods, this technique replaces traditional transverse stirrups with steel sheets, providing enhanced confinement and ductility.
Ahmed Hamoda, Khaled Sennah, Ramy I. Shahin, Aref A. Abadel, Mizan Ahmed, Mohamed Ghalla   +5 more
wiley   +1 more source