Results 201 to 210 of about 6,236 (302)

Failure mechanism and resistance predictions for one‐way slabs in transition between shear and punching coupling linear elastic finite element analyses with critical shear crack theory‐based models

Structural Concrete, EarlyView.
Abstract Linear elastic finite element analyses (LEFEAs) have become more frequent in the design and assessment of reinforced concrete slabs under concentrated loads, as they enable low‐cost evaluation of the distribution of shear forces over critical sections.
Alex Micael Dantas de Sousa, Eva Olivia Leontien Lantsoght, Andri Setiawan, Mounir Khalil El Debs   +3 more
wiley   +1 more source

TRM‐to‐concrete interface bond without anchors: Combined experimental, analytical, and numerical modeling approach

Structural Concrete, EarlyView.
Abstract Textile reinforced mortar (TRM) systems have emerged as an effective alternative to conventional FRP strengthening solutions due to their compatibility with concrete substrates and favorable performance under adverse environmental conditions.
Ömer Mercimek, Özlem Çalışkan, Özgür Anıl, R. Tuğrul Erdem, Murat Yüncüler   +4 more
wiley   +1 more source

Clinical Implications of Sterilization Methods Applied to 3D-Printed Implant Surgical Guides: An In Vitro Study. [PDF]

Int Dent J
Go HB, Kim GT, Yu JH, Yoon Y, Kwon JS.
europepmc   +1 more source

Techniques for the measurement of the flexural rigidity of thin films and laminates

, 1966
H. L. Price
openalex   +1 more source

Effects of Width, Length and Flexural Rigidities of Ski on Ski Turn.

, 1998
Toshiyuki SAKATA, Noriyuki Tani, Tatsuya SIMAZAKI   +2 more
openalex   +2 more sources

Analysis of the influence of supplementary reinforcement on the behavior of reinforced‐concrete two‐pile caps subjected to concentric and eccentric loading

Structural Concrete, EarlyView.
Abstract This article examines the behavior of reinforced‐concrete pile caps on two piles under concentric and eccentric loading, with emphasis on the influence of horizontal and vertical supplementary reinforcement on load‐carrying capacity. Although the Strut‐and‐Tie method does not include this reinforcement in the internal equilibrium, it was found
Marcio Ferreira Cardoso, Ricardo de Paula Randi, Thomaz Eduardo Teixeira Buttignol, Luiz Carlos de Almeida, Leandro Mouta Trautwein   +4 more
wiley   +1 more source

High-performance eco-concrete beams with calcined montmorillonite, metakaolin pyrolyzed coffee grounds, and hybrid fibers for enhanced bending strength and microstructural refinement. [PDF]

PLoS One
Hepautwa AA, Hilonga A, Mrosso R, Alfredy T, Mwalusambo G, Lesafi F, Chande Jande YA.   +6 more
europepmc   +1 more source

Measuring Flexural Rigidity of Fabrics by a Vibrating Disk Method

, 1968
Hidejiro Owaki
openalex   +2 more sources

Polyamide Acid–Based Surface Modification of Poly(p‐Phenylene Benzobisoxazole) Fibres Reinforcing Syntactic Foam for Using Them as High‐Performance Insulating Core Material

High Voltage, EarlyView.
ABSTRACT The insulating core is an important part of pillar composite insulators used in power transmission systems. Traditional insulating core materials suffer from various problems that can threaten the reliability of insulated equipment. Syntactic foam (SF) exhibits excellent properties, such as a low density, water penetration resistance and high ...
Le Li, Xingdou Li, Zhuangzhuang Li, Chi Wang, Yang Wang, Wenhua Wu, Lei Yang, Jinxiang Liang, Yunpeng Liu   +8 more
wiley   +1 more source

Chemical and structural characterization of ramie-based epoxy composites reinforced with macadamia nut shell biochar. [PDF]

Sci Rep
Palaniappan M, Kumar PM, Sivanantham G, Gebreyohannes DT.   +3 more
europepmc   +1 more source