Results 21 to 30 of about 1,634,384 (168)
Identifying and Standardized Setting Method of Overlap Degree of DEH System Regulating Valve
Zhongguo dianli, 2020 According to the principle of steam turbine, the connotation and function of the overlap degree of the regulating valve of DEH system are analyzed in-depth with the overlapping measurement indices established.
Zhonghai WAN +4 more
doaj +1 more source
Mathematics, 2022 In this study, isothermal compression tests of highly ductile AZ31-0.5Ca Mg alloys were conducted at different strain rates (0.001–0.1 s−1) and temperatures (423–523 K) along with extruded direction.
Umer Masood Chaudry +5 more
doaj +1 more source
New Numerical and Measurements Flow Analyses Near Radars
Applied Mechanics, 2021 An experimental and numerical investigation of the flow near a blunt body has been conducted in this study. Most experimental methods of flow studies use flow visualization and probes introduction into the flow field.
Manuel Flores Salinas +2 more
doaj +1 more source
Micromachines, 2021 This paper focuses on the flow and thermal characteristics of the lubricant film in the micro clearance of a hydrodynamic journal bearing (HJB) at high rotating speed.
Yulong Jiang +4 more
doaj +1 more source
The flow characteristics of superplasticity [PDF]
Letters on Materials, 2014 1Division of Materials Science and Engineering, Hanyang University, 133–791, Seoul, South Korea 2Departments of Aerospace & Mechanical Engineering and Materials Science, University of Southern California, Los Angeles, CA 90089-1453, USA CA 90089–1453, Los Angeles, USA 3Department of Materials Engineering and Civil Construction, Universidade Federal de ...
Kawasaki, Megumi +2 more
openaire +1 more source
Flow Characteristics of the Entrance Region with Roughness Effect within Rectangular Microchannels
Micromachines, 2019 We conducted systematic numerical investigations of the flow characteristics within the entrance region of rectangular microchannels. The effects of the geometrical aspect ratio and roughness on entrance lengths were analyzed.
Haiwang Li +3 more
doaj +1 more source
Micromachines, 2022 This paper proposed an improved flow-focusing microchannel with a constricted continuous phase inlet to increase microbubble generation frequency and reduce microbubbles’ diameter.
Zhaohui Wang +5 more
doaj +1 more source
Soils and Foundations, 1973 ABSTRACT Based on a critical review of the available data in creep tests previously published by many investigators, a new concept of flow envelope is presented and substantiated for normally consolidated clays. It is shown that the flow envelope is expressed by a simple equation irrespective of the type of clays, water content, drainage condition ...
openaire +2 more sources
Energies, 2023 In this paper, an improved RSM-CFD method is used to optimally design a mixed turbine of non-equilibrium condensing steam (NECS) and hydrogen (H2), of which the response surface method (RSM) and computational fluid dynamics (CFD) are coupled to take into
Liangchuan Wei +3 more
doaj +1 more source
Flow characteristics of a centrifugal pump with different impeller trimming methods [PDF]
FME Transactions, 2018 Influences of different impeller trimming methods on flow characteristics of a centrifugal pump have been studied numerically and experimentally in this research.
Khoeini Davood, Tavakoli Mohammad Reza
doaj