Results 61 to 70 of about 43,969 (311)
3D Printing of Soft Robotic Systems: Advances in Fabrication Strategies and Future Trends
Collectively, this review systematically examines 3D‐printed soft robotics, encompassing material selections, function integration, and manufacturing methodologies. Meanwhile, fabrication strategies are analyzed in order of increasing complexity, highlighting persistent challenges with proposed solutions.
Changjiang Liu +5 more
wiley +1 more source
Simulation and sensitivity analysis of a natural gas liquefaction cycle
A sensitivity analysis of a Natural Gas (NG) Liquefaction Cycle with mixed refrigerant was done varying the operational conditions. It was used PROII/8.1® to simulate the process and in each case study the variation of the coefficient of performance (COP)
Sabrina Di Scipio +3 more
doaj
Modification of a pilot-scale continuous flow reactor for hydrothermal liquefaction of wet biomass
A pilot-scale continuous flow reactor (CFR) was modified for hydrothermal liquefaction (HTL) of algae slurry under subcritical conditions to investigate the feasibility of scaling up from batch to continuous processing.
Feng Cheng +7 more
doaj +1 more source
Compared with quartz sand, recycled aggregate sand is characterized by the high liquefaction and shear resistance because of its irregular particle shape.
Guanyu Chen +6 more
doaj +1 more source
Unified analysis of liquefaction and the ground flow phenomenon [PDF]
Loose saturated sand behaves as a solid before liquefaction but as a fluid when the excess pore water pressure equals the initial confining stress, after which it recovers its strength. A simple constitutive equation for loose saturated sand was developed to express the phase transformation between a solid and fluid during liquefaction and the ground ...
Tae-Hoon Kim, Yong-Seong Kim
openaire +1 more source
Overview geotechnical model tests on dike safety at Deltares [PDF]
Three on-going dike safety studies (on: macro stability, piping and flow slides) in the Netherlands make use of geotechnical physical models. A short outline of these projects is presented; the physical models chosen are described and discussed.
Bezuijen, Adam +3 more
core +1 more source
This study presents a novel 4D bioprinting platform for engineering biomimetic musculoskeletal grafts. By tuning the mechanical properties of support baths, we enhance tissue fusion, collagen alignment, and cell differentiation. Using this strategy, we successfully fabricate scaled‐up, anisotropic tissues such as meniscus, articular cartilage, and ...
Francesca D. Spagnuolo +2 more
wiley +1 more source
This study presents an intravesical delivery strategy of ferroptosis‐ and immunity‐inducing nanozyme‐loaded thermoresponsive hydrogels (FMCC@PNH) for enhanced bladder cancer therapy. Abstract Current intravesical therapies for bladder cancer after resection are limited by poor tissue penetration, off‐target effects, and insufficient efficacy.
Yongnan Jiang +11 more
wiley +1 more source
In complex marine environments, the wave-induced instantaneous liquefaction of the seabed is a key issue for the long-term safety control of marine structures.
Shichong Han +5 more
doaj +1 more source
Note: "Lock-in accelerometry" to follow sink dynamics in shaken granular matter [PDF]
Understanding the penetration dynamics of intruders in granular beds is relevant not only for fundamental Physics, but also for geophysical processes and construction on sediments or granular soils in areas potentially affected by earthquakes.
A. J. Batista-Leyva +9 more
core +4 more sources

