Results 31 to 40 of about 227,059 (254)

Analyzing the discharge regime of a large tropical river through remote sensing, ground-based climatic data, and modeling [PDF]

, 1996
This study demonstrates the potential for applying passive microwave satellite sensor data to infer the discharge dynamics of large river systems using the main stem Amazon as a test case.
Annette L. Schloss, Arkin, Baumgartner, Bhaskar J. Choudhury, Birkett, Chahine, Charles J. Vörösmarty, Choudhury, Choudhury, Choudhury, Committee on Global Change, Cort J. Willmott, Defense Mapping Agency Aerospace Center (DMAAC), Defense Mapping Agency Aerospace Center (DMAAC), Defense Mapping Agency Aerospace Center (DMAAC), Defense Mapping Agency Aerospace Center (DMAAC), Defense Mapping Agency Aerospace Center (DMAAC), Defense Mapping Agency Aerospace Center (DMAAC), Dickinson, Dümenil, Giddings, Global Runoff Data Centre (GRDC), Imhoff, Koblinsky, Korzoun, Lean, Leeden, Legates, Legates, Meade, Melillo, Mintz, Mintz, Morris, Nepstad, Pierce, Rastetter, Richey, Rodda, Rzóska, Salati, Salati, Scott M. Robeson, Serafini, Shukla, Sioli, Sippel, Sippel, Skole, Timothy J. Dorman, Timothy K. Stearns, Vörösmarty, Vörösmarty, Vörösmarty, Webb, Willmott, Willmott, Willmott, Willmott, Willmott, Willmott   +60 more
core   +2 more sources

Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6

Advanced Engineering Materials, EarlyView.
The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter, Thomas Wegener, Andreas Schilling, Martin Fehlbier, Thomas Niendorf   +4 more
wiley   +1 more source

Thermal-structural design study of an airframe-integrated Scramjet [PDF]

Design concepts are developed and evaluated for a cooled structures assembly for the Scramjet engine, for engine subsystems mass, volume, and operating requirements, and for the aircraft/engine interface.
Katinsky, E. A., Killackey, J. J., Tepper, S., Vuigner, A. A.   +3 more
core   +4 more sources

Nitride‐Reinforced Metal Matrix Nanocomposite Powders Production by Plasma‐Assisted Thermochemical Treatment of Intermetallic Powders

Advanced Engineering Materials, EarlyView.
This study proposes a new methodology for producing metal matrix nanocomposites in the solid state. The process involves the plasma‐assisted thermochemical treatment of metallic alloy powders. As a proof‐of‐concept, TiN nanoparticles are synthesized directly on the surface of FeTi intermetallic powder particles, enabling the development of the ...
Deivison Daros Paim, Antônio Rogério de Souza, Tatiana Bendo, Aloisio Nelmo Klein, Rodrigo Perito Cardoso   +4 more
wiley   +1 more source

Evaluation of the Land Surface Water Budget in NCEP/NCAR and NCEP/DOE Reanalyses using an Off-line Hydrologic Model [PDF]

, 2001
The ability of the National Centers for Environmental Prediction (NCEP)/National Center for Atmospheric Research (NCAR) reanalysis (NRA1) and the follow-up NCEP/Department of Energy (DOE) reanalysis (NRA2), to reproduce the hydrologic budgets over the ...
Lettenmaier, Dennis P., Maurer, Edwin P., O\u27Donnell, Greg M.   +2 more
core   +1 more source

JASPER: Joint Optimization of Scaling, Placement, and Routing of Virtual Network Services

, 2017
To adapt to continuously changing workloads in networks, components of the running network services may need to be replicated (scaling the network service) and allocated to physical resources (placement) dynamically, also necessitating dynamic re-routing
Dräxler, Sevil, Karl, Holger, Mann, Zoltán Ádám   +2 more
core   +1 more source

Technical Design Report for the PANDA Solenoid and Dipole Spectrometer Magnets [PDF]

, 2009
This document is the Technical Design Report covering the two large spectrometer magnets of the PANDA detector set-up. It shows the conceptual design of the magnets and their anticipated performance. It precedes the tender and procurement of the magnets
Clarkson, T., Cowie, E., Downie, E., Erni, W., Hill, G., Hoek, M., Ireland, D., Kaiser, R., Keri, T., Lehmann, I., Livingston, K., Lumsden, S., MacGregor, D., McKinnon, B., Murray, M., Protopopescu, D., Rosner, G., Seitz, B., The PANDA collaboration, Yang, G.   +19 more
core   +3 more sources

Influence of Sample Preparation and Processing Procedures on the Thermal Diffusivity of MgO‐C Refractories

Advanced Engineering Materials, EarlyView.
The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan, Rhena Wulf, Till M. J. Stadtmüller, Christos G. Aneziris, Tobias M. Fieback   +4 more
wiley   +1 more source

Organic Electrochemical Transistor Channel Materials: Copolymerization Versus Physical Mixing of Glycolated and Alkoxylated Polymers

Advanced Functional Materials, EarlyView.
This work discusses the use of blended channel materials in OECTs. It explores how mixing glycolated and alkoxylated polymers in various ratios offers a simpler and more efficient route to tuning OECT properties. The performance of the polymer blends is compared to the corresponding copolymers, demonstrating similar OECT characteristics, swelling ...
Lize Bynens, Kaishuai Zhang, Priscila Cavassin, Arwin Goossens, Jochen Vanderspikken, Tania C. H. Castillo, Demetra Tsokkou, Adam Marks, Arianna Magni, Karrie Weaver, Laurence Lutsen, Sahika Inal, Koen Vandewal, Natalie Banerji, Wouter Maes   +14 more
wiley   +1 more source

Dual‐Mode Film Based on Highly Scattering Nanofibers and Upcycled Chips‐Bags for Year‐Round Thermal Management

Advanced Functional Materials, EarlyView.
Intelligent radiative cooling devices, adaptable to various weather conditions, have the potential for year‐round energy savings. This study introduces a sustainable dual‐mode film made from polycaprolactone nanofibers and upcycled chip bags for effective thermal management.
Qimeng Song, Stefan Rettinger, Chengzhang Xu, Ulrich Mansfeld, Markus Retsch   +4 more
wiley   +1 more source