Results 151 to 160 of about 2,004,002 (204)
Membrane Technologies for Bioengineering Microalgae: Sustainable Applications in Biomass Production, Carbon Capture, and Industrial Wastewater Valorization. [PDF]
Membranes (Basel)Morais MG +4 more
europepmc +1 more source
The benefits of flue gas recirculation in waste incineration
Waste Management, 2007 Flue gas recirculation in the incinerator combustion chamber is an operative technique that offers substantial benefits in managing waste incineration. The advantages that can be obtained are both economic and environmental and are determined by the low flow rate of fumes actually emitted if compared to the flue gas released when recirculation is not ...
LIUZZO, Giuseppe +2 more
openaire +4 more sources
Co2 Capture for the Silicon Process-Effects of Flue Gas Recirculation [PDF]
SSRN Electronic Journal, 2021 Flue gas recirculation has been proposed as a potential process improvement for the silicon and ferrosilicon process. In this paper, flue gas flows and concentration from a 100 MW silicon production operation has been calculated for 0, 25, 50, 62.5 and 75 % flue gas recirculation.
Vegar Andersen +5 more
openaire +2 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Flue gas recirculation in a gas-fired laboratory furnace: Measurements and modelling
Fuel, 1997This paper presents an experimental and numerical study of the effect of flue gas recirculation (FGR) on flame characteristics and pollutant emissions. The experimental study was performed in a small-scale laboratory furnace fired by a gas swirl burner of industrial type.
Maria da Graça Carvalho +2 more
exaly +2 more sources
Flue gas recirculation in iron ore sintering process
Ironmaking and Steelmaking, 2016Flue gas recirculation has been introduced into iron ore sintering process to reduce pollutant emissions. Compared with the conventional process, the sintering indices reduce gradually with decreasing O2 content in the recirculating gas. With sufficient O2, the principle on the use of flue gas recirculation is proposed.
M Gan
exaly +2 more sources
Flue Gas Recirculation during Biomass Combustion: Implications on PM Release
Energy & Fuels, 2020 The need for low-emission technologies in biomass domestic heating systems has encouraged the development of primary methods to improve the combustion process. Air-injection strategies are known to yield successful results regarding gaseous emissions; however, their implication on PM release still has some unknowns.
Raquel Pérez-Orozco +3 more
openaire +3 more sources
Study of Flue-Gas Recirculation Sintering
Metallurgist, 2017The sintering process in a sinter machine with a sintering area of 224 m2 involving recirculation of flue gas to reduce the emission of harmful substances into the atmosphere and its flow through a bag filter to be installed after the existing electrostatic precipitator is analyzed.
Yu. A. Frolov +2 more
openaire +1 more source
Flue Gas Recirculation in a Gas Turbine: Impact on Performance and Operational Behavior
Volume 4: Cycle Innovations; Fans and Blowers; Industrial and Cogeneration; Manufacturing Materials and Metallurgy; Marine; Oil and Gas Applications, 2011The rigorous reduction of greenhouse gas emissions in the upcoming decades is only achievable with contribution from the following strategies: production efficiency, demand reduction of energy and carbon dioxide (CO2) capture from fossil fueled power plants.
Frank Sander +3 more
openaire +1 more source
Effect of H2O(g) Content in Circulating Flue Gas on Iron Ore Sintering with Flue Gas Recirculation
Journal of Iron and Steel Research International, 2015The influence of H2O (g) content in circulating flue gas on sintering was studied by simulating the flue gas circulating sintering. The results show that the burning speed of solid fuel and the heat transfer rate during sintering process are improved when the H2O (g) content increases from 0 to 6%, which accelerates the sintering speed.
Xu-ling Chen +5 more
openaire +1 more source
Transactions of the Korean Society of Mechanical Engineers B, 2004
Investigation on Flue Gas Recirculation(FGR) flame and Fuel Injection Recirculation(FIR) flame was performed with numerical method. Quantitative Reaction Path Diagram(QRPD) is utilized to compare the different chemistry effects between FGR flame and FIR flame.
openaire +1 more source
Investigation on Flue Gas Recirculation(FGR) flame and Fuel Injection Recirculation(FIR) flame was performed with numerical method. Quantitative Reaction Path Diagram(QRPD) is utilized to compare the different chemistry effects between FGR flame and FIR flame.
openaire +1 more source