Results 21 to 30 of about 28,187 (272)
Development of a novel thermoacoustic flue-gas analyzer
AIP Advances, 2020 Flue gas analyzers, such as those based on electrochemical cells and infrared sensors, are commonly used to determine the molar concentrations of the different species of flue-gas mixtures and provide information about the associated air-fuel ratio and ...
M. Aziz, H. Saleh, A. Abd El-Rahman
doaj +1 more source
The radiowave sensors of thermal power stations flue-gas [PDF]
Технологія та конструювання в електронній апаратурі, 2009 The possibility of creating sensors that can provide continuous monitoring of gas compositions is being considered. In the sensor, it is used a spectroscopic effect of resonant absorption of electromagnetic waves when they pass through different media ...
P. E. Ivanova +3 more
doaj +1 more source
Numerical modelling of a stoker furnace operated under indirect co-firing of biomass
Chemical and Process Engineering, 2016 The subject of the CFD analysis presented in this paper is the process of biomass indirect co-firing carried out in a system composed of a stoker-fired furnace coupled with a gasification reactor.
Litka Rafał, Kalisz Sylwester
doaj +1 more source
A novel multi-jet burner for hot flue gases of wide range of temperatures and compositions for optical diagnostics of solid fuels gasification/combustion [PDF]
Review of Scientific Instruments, 2017 A novel multi-jet burner was built to provide one-dimensional laminar flat flames with a wide range of variable parameters for multipurpose quantitative optical measurements. The burner is characterized by two independent plenum chambers, one supporting a matrix of 181 laminar jet flames and the other supporting a co-flow from a perforated plate with ...
Wubin Weng +4 more
openaire +2 more sources
Litiyo i Metallurgiya (FOUNDRY PRODUCTION AND METALLURGY), 2019 The possibility of using the deposited suspended particles of electric arc furnaces as heat-resistant modifying additives for friction composites is considered. It is shown that the precipitated particles obtained during the smelting of steel of different grades have identical morphology and are a homogeneous mechanical mixture consisting mainly of ...
T. A. Akhmetov +2 more
openaire +3 more sources
Interaction of an Eulerian flue gas plume with wind turbines [PDF]
, 2010 The reduced availability of sites with the requisite wind resource, planning permission and public acceptance for the placement of wind turbines poses a significant challenge to future expansion of the wind energy industry.
Fletcher T.M. +3 more
core +1 more source
Applied Sciences, 2020 Cylinder-shaped fuel pellets that were 3 mm in diameter and 3 mm in height, with a mass of 20 mg, were produced by compressing dry coal processing waste under the pressure of 5 MPa. The first group of pellets from coal dust with a particle size less than
Dmitriy Klepikov +3 more
doaj +1 more source
Energy Reports, 2020 In power plants or any combustion systems, for a maximum efficiency of combustion, an operational safety procedure (reduction of CO emissions) and environmental pollution reduction, it is highly important to determine and monitor the flue gas composition
Lizica Simona Paraschiv +2 more
doaj +1 more source
Applied Sciences, 2021 In this work, we experimentally investigated the effect of widespread biomass (woodworking waste—pine sawdust) in the composition of mixed fuel, formed also using the widespread steam coals metalignitous (D) and lean (T), on the concentration of sulfur ...
Stanislav Yankovsky +4 more
doaj +1 more source
Process analysis of pressurized oxy-coal power cycle for carbon capture application integrated with liquid air power generation and binary cycle engines [PDF]
, 2015 In this paper, the thermodynamic advantage of integrating liquid air power generation (LAPG) process and binary cycle waste heat recovery technology to a standalone pressurized oxy-coal combustion supercritical steam power generation cycle is ...
Aneke, Mathew, Wang, Meihong
core +1 more source