Results 71 to 80 of about 3,374,665 (395)

Evaluation of a series hybrid thrust bearing at DN values to three million. 2: Fabrication and testing [PDF]

open access: yes
Results of tests made to determine the experimental performance of a series hybrid bearing are reported. The bearing consists of a 150 mm ball bearing and a centrifugally actuated, conical, fluid film bearing fitting an envelope with an outer radius of ...
Eusepi, M., Winn, L. W.
core   +1 more source

A theoretical model for determining turbine flowmeter sensitivity [PDF]

open access: yes, 1967
Analytical model of turbine-type flowmeter guides in the selection of valid extrapolation of available calibration data. An expression for flowmeter performance is developed to include the effects of fluid friction, bearing drag, and magnetic drag upon ...
Smith, R. L.
core   +1 more source

Design and application of squeeze film dampers for turbomachinery stabilization [PDF]

open access: yes, 1975
The steady-state transient response of the squeeze film damper bearing was investigated. Both the steady-state and transient equations for the hydrodynamic bearing forces are derived; the steady-state equations were used to determine the damper ...
Allaire, P. E.   +2 more
core   +2 more sources

LINC01116, a hypoxia‐lncRNA marker of pathological lymphangiogenesis and poor prognosis in lung adenocarcinoma

open access: yesMolecular Oncology, EarlyView.
The LINC01116 long noncoding RNA is induced by hypoxia and associated with poor prognosis and high recurrence rates in two cohorts of lung adenocarcinoma patients. Here, we demonstrate that besides its expression in cancer cells, LINC01116 is markedly expressed in lymphatic endothelial cells of the tumor stroma in which it participates in hypoxia ...
Marine Gautier‐Isola   +12 more
wiley   +1 more source

Design and evaluation of a 3 million DN series-hybrid thrust bearing [PDF]

open access: yes
The bearing, consisting of a 150-mm ball bearing and a centrifugally actuated, conical, fluid-film bearing, was fatigue tested. Test conditions were representative of a mainshaft ball bearing in a gas turbine engine operating at maximum thrust load to ...
Eusepi, M., Scibbe, H. W., Winn, L. W.
core   +1 more source

ATF4‐mediated stress response as a therapeutic vulnerability in chordoma

open access: yesMolecular Oncology, EarlyView.
We screened 5 chordoma cell lines against 100+ inhibitors of epigenetic and metabolic pathways and kinases and identified halofuginone, a tRNA synthetase inhibitor. Mechanistically halofuginone induces an integrated stress response, with eIF2alpha phosphorylation, activation of ATF4 and its target genes CHOP, ASNS, INHBE leading to cell death ...
Lucia Cottone   +11 more
wiley   +1 more source

Stryker Osteonics: Prosthetic Knee Joint [PDF]

open access: yes, 2008
We examine, within a simple bearing model of a knee joint that only consideres pure sliding, the effect of the presence of a small vertical hole in the load area on the fluid film properties.
Hjorth, P.G.   +5 more
core  

Developing evidence‐based, cost‐effective P4 cancer medicine for driving innovation in prevention, therapeutics, patient care and reducing healthcare inequalities

open access: yesMolecular Oncology, EarlyView.
The cancer problem is increasing globally with projections up to the year 2050 showing unfavourable outcomes in terms of incidence and cancer‐related deaths. The main challenges are prevention, improved therapeutics resulting in increased cure rates and enhanced health‐related quality of life.
Ulrik Ringborg   +43 more
wiley   +1 more source

Evaluation of a hybrid hydrostatic bearing for cryogenic turbopump application [PDF]

open access: yes
A hybrid hydrostatic bearing was designed to operate in liquid hydrogen at speeds to 80,000 rpm and radial loads to 440 n (100 lbf). The bearing assembly consisted of a pair of 20-mm angular-contact ball bearings encased in a journal, which was in turn ...
Hannum, N. P.   +2 more
core   +1 more source

Response of a warped flexible rotor with a fluid bearing

open access: yes, 2008
A two-complex-degrees-of-freedom model is developed and compared to experimental data for various amounts of rotor bow and its orientation to mass imbalance of the rotor.
J. Meagher, Xi Wu, Chris Lencioni
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy