Results 81 to 90 of about 39,586 (279)
Hydrometallurgy of the delta sulfide ores, second stage report [PDF]
This report contains results of the Fluidized-Bed Leaching (FBL) initially adapted to improve Leaching-Flotation processing of Delta ores in sulfate solution. The research carried out in the continuous laboratory installation show, however, that the new,
Letowski, F., Rao, P.D.
core
Techno-economic analysis of chemical looping combustion with humid air turbine power cycle [PDF]
Power generation from fossil fuel-fired power plant is the largest single source of CO₂ emission. CO₂ emission contributes to climate change. On the other hand, renewable energy is hindered by complex constraints in dealing with large scale application ...
Brandvoll +6 more
core +2 more sources
Abstract Synthetic jet fuel containing non‐petroleum‐derived kerosene can be produced from synthetic kerosene obtained through processes that include a hydroprocessing step. The potential use of non‐sulphided (reduced) nickel supported on alumina (Ni/Al2O3) was evaluated as an alternative to sulphided catalysts to saturate alkenes in sulphur‐free ...
Garima Chauhan +3 more
wiley +1 more source
A study of Ni‐Co/CeO2 catalyst derived from metal–organic framework for dry reforming of methane
Abstract The efficacy of cobalt‐doped, MOF‐derived catalysts for dry reforming of methane (DRM) was examined. The focus was on the influence of varying nickel and cobalt molar ratios on catalytic performance. Three catalysts with Ni:Co ratios of 1:1, 1:0.5, and 0.5:1, were synthesized and tested with cerium oxide as a constant support. The DRM reaction
Ruth D. Alli, Nader Mahinpey
wiley +1 more source
Thermochemical conversion of sugarcane bagasse into bio-crude oils by fluidized-bed reactor has been taken into consideration in this study. The bagasse in particle form was pyrolyzed in an externally heated 7cm diameter and 37.5cm high fluidized-bed ...
Mohammad Rofiqul ISLAM +3 more
doaj +1 more source
Abstract Several authors have reported the disconnection between the skills, abilities, and attitudes of graduates from STEM careers with the current needs of the labour market. In science and engineering fields, research has found the need for interdisciplinary approaches that encourage meaningful learning.
Úrsula Manríquez‐Tolsá +7 more
wiley +1 more source
Fluidized-bed development at JPL [PDF]
Silicon deposition on silicon seed particles by silane pyrolysis in a fluidized bed reactor (FBR) was investigated as a low cost, high throughput method to produce high purity polysilicon for solar cell applications.
Hsu, G.
core +1 more source
Modelling of continuous low‐temperature emulsion co‐polymerization in 3D‐printed reactor
A kinetic model for the emulsion copolymerization of butyl acrylate/styrene at low temperatures is proposed and validated against experiments with a redox initiator system. The model was successfully transferred to a 3D‐printed tubular reactor and conversions of more than 80% and small particles sizes below 40 nm were observed.
Ferel Issa +2 more
wiley +1 more source
Optimization of Fluidized Bed Isothermal Reactor in a Styrene Production Process [PDF]
The focus of this thesis is to explain the optimization of a fluidized bed isothermal reactor in a styrene production process. The first section of the thesis gives a summary of chemical process optimization in general.
Peaster, Matthew Hamilton
core +1 more source
High temperature annealing of micrometric Zn2SiO4:Mn phosphor powders in fluidized bed [PDF]
Micrometric Zn1.8Mn0.2SiO4 phosphor powders prepared by spray pyrolysis have been annealed between 900 and 1200°C under ambient air atmosphere to exalt their luminescence properties. Two original gas-solid fluidization processes have been tested in order
Alavi, Shila +2 more
core +2 more sources

