Results 211 to 220 of about 1,311 (265)
Some of the next articles are maybe not open access.

Design of a fluidized bed scrubber

Industrial & Engineering Chemistry Process Design and Development, 1985
Current design of the fluidized bed scrubber (FBS), otherwise known as the Turbulent Contact Absorber or the Mobile Bed Contactor, is based on experience and rules of thumb. In this paper published equations on hydrodynamics and mass transfer are reviewed. From the equations a logical design procedure for the FBS Is proposed.
Visvanathan C., Leung L.S.
openaire   +3 more sources

Dynamics of a shallow fluidized bed

Physical Review E, 1999
The results of the experimental study of the dynamics of a shallow fluidized bed are reported. The behavior of granular material is controlled by the interplay of two factors--levitation due to the upward airflow, and sliding back due to gravity. Near the threshold of instability, the system shows critical behavior with remarkably long transient ...
L S, Tsimring, R, Ramaswamy, P, Sherman
openaire   +2 more sources

Influence of Fluidization Velocity on Bed Defluidization in Fluidized Bed Combustors

18th International Conference on Fluidized Bed Combustion, 2005
Effects of superficial gas velocity and bed particle size on bed defluidization during biomass combustion were investigated. Sampled bed particles from four different large-scale circulating- and bubbling fluidized bed combustors, using biomass as fuel, were collected and analyzed.
Mohammad R. Golriz   +4 more
openaire   +1 more source

Biological denitrification in a fluidized bed

Biotechnology and Bioengineering, 1984
AbstractA fluidized bed biofilm reactor using sand as the carrier particle was employed to study the effects of superficial velocity on the removal of nitrates as well as on the growth of the biofilm. Velocity was found to affect significantly both nitrate removal and biofilm growth.
NARJARI, NK, KHILAR, KC, MAHAJAN, SP
openaire   +3 more sources

The development of fluidized bed combustion

Environmental Science & Technology, 1980
Technical feature:The development of fluidized-bed combustion (FBC) technology in the U.K. during the 1960's and beyond is reported. FBC technology was developed to reduce the capital costs of coal combustion and to facilitate the efficient use of lower grade coal. The status of operating FBC boilers in the U.K. is examined.
openaire   +2 more sources

Fluidization of nanoagglomerates in a rotating fluidized bed

AIChE Journal, 2006
AbstractAgglomerates of nanoparticles were fluidized in a rotating fluidized bed (RFB) system at different rotating speeds corresponding to 10, 20, 30 and 40 times the gravity force (9.8 m/s2). The powders, fumed silica Aerosil® R974, Aerosil® R972 and Aeroxide® TiO2 P25, with a primary particle size of 12, 16 and 21 nm, respectively, form micron sized
Jose Quevedo   +5 more
openaire   +1 more source

Fluidization of cylinder particles in a fluidized bed

Advanced Powder Technology, 2017
Abstract An experimental study of the flow regimes and transitions in a fluidized bed (cross-section of 200 mm × 200 mm and height of 2000 mm) containing a mixture of cylindrical particles and silica sand is carried out. Six different flow regimes are identified: fixed bed (F), bubbling fluidization (B), transition fluidization (T), partial ...
Xi Chen   +2 more
openaire   +1 more source

Nonlinear Instabilities in Fluidized Beds

Annals of the New York Academy of Sciences, 1983
Abstract The interpretation of linear instabilities of voidage disturbances in fluidized beds (ref. 12) is reviewed and the natural extension to nonlinear instabilities presented in the light of interpretation of observations (refs. 9, 10). The role of the constitutive relations in the analysis is also discussed.
openaire   +1 more source

Crystalline fluidized beds

Physical Review E, 1995
, Rutgers   +4 more
openaire   +2 more sources

FLUIDIZED-BED PYROLYSIS OF GLUCOMANNAN

2013
The pyrolysis of particles of glucomannan, the main component of softwood hemicelluloses, is investigated in a fluidized-bed reactor. A first set of experiments is carried out for temperatures in the range 530-690K to determine yields and composition of products. The most abundant are char, water and carbon dioxide.
C Branca, A Galgano, C Di Blasi
openaire   +5 more sources

Home - About - Disclaimer - Privacy