Results 11 to 20 of about 65,441 (342)
CES Transactions on Electrical Machines and Systems, 2022 In electrolytic capacitorless permanent magnet synchronous motor (PMSM) drives, the DC-link voltage will fluctuate in a wide range due to the use of slim film capacitor. When the flux-weakening current is lower than −ψf/Ld during the high speed operation,
Junya Huo +6 more
doaj +2 more sources
Control Strategies for Open-End Winding Drives Operating in the Flux-Weakening Region [PDF]
, 2013 This paper presents and compares control strategies for three-phase open-end winding drives operating in the flux-weakening region. A six-leg inverter with a single dc-link is associated with the machine in order to use a single energy source.
Paul Sandulescu +4 more
openalex +8 more sources
Traction Permanent Magnet Synchronous Motor Torque Control with Flux Weakening [PDF]
Radioengineering, 2009 The paper deals with analysis of dynamic behavior of a feedback flux weakening control of PMSM traction drive for light vehicles. The PMSM flux weakening is very important for traction drives.
J. Novak, O. Cerny, R. Dolecek
doaj +2 more sources
Flux weakening control of permanent magnet machine based aircraft electric starter-generator [PDF]
, 2016 This paper presents control analysis and design for an aircraft electric starter-generator system based on a Permanent Magnet Machine (PMM) operated in Flux-Weakening mode (FW).
Serhiy Bozhko +4 more
openalex +4 more sources
IEEE Access, 2017 Under grid-voltage dips, there exist dc and negative sequence components in the stator and rotor flux of doubly-fed induction generator (DFIG). As a result, higher transient overcurrent is generated in the rotor.
Meng Wang +4 more
doaj +2 more sources
Comparative Performance of Induction Motor Speed Controller System with Flux Weakening Control
IOP Conference Series: Materials Science and Engineering, 2021 Abstract In general induction motor not work optimally because cannot reach the maximum speed of the rating. In this paper, simulation is used with several methods, named Maximum Torque Per Ampere (MTPA) and Field-weakening. Simulation of the methods used the function on MATLAB C-Mex and implemented on block of Simulink.
Regina Chelinia Erianda Putri +1 more
openalex +2 more sources
A Novel High-Performance Field-Weakening Control for Axial Flux-Switching Permanent-Magnet Motor
Iranian Journal of Electrical and Electronic Engineering, 2020 By combining the field-weakening control principle of a new axial flux-switching permanent-magnet motor (AFFSSPM) with the space vector pulse width modulation (SVPWM) and maximum torque per voltage (MTPV) control principle, a novel field-weakening ...
J. Rahmani Fard
doaj +1 more source
Space Vector Flux Weakening Control of PMSM Drivers
IOP Conference Series: Earth and Environmental Science, 2018 Gentao Dong +4 more
openalex +2 more sources
Integral Sliding Mode Controller for PMSM Single Current Flux-Weakening Control
机车电传动, 2018 An improved sliding mode speed controller was presented for flux-weakening control of permanent magnet synchronous machine (PMSM) based on single current regulation algorithm, to improve the controllability of the speed of the single current regulator ...
Cao Yu, Chi Song
doaj +1 more source
Fuzzy Self-tuning PI Controller for Field-weakening Control System of an Axial Flux Switching Permanent Magnet Motor [PDF]
AUT Journal of Electrical Engineering, 2021 In this paper, based on the vector control of axial field flux switching permanent magnet (AFFSPM) motor, an optimized field-weakening control method of AFFSPM motor is proposed. A new AFFSPM motor with 12 stator slots (S) and 19 rotor poles (P) is taken
Hamid Radmanesh, Javad Rahmani Fard
doaj +1 more source