Results 21 to 30 of about 14,740 (209)
Research on Peak‐to‐Average Power Ratio Control Method for Switched Reluctance Pulse Generator
IET Electric Power Applications, Volume 20, Issue 1, January/December 2026.Addressing the different requirements for peak output power when SRPG supplies power to pulse loads and DC loads, the peak‐to‐average power ratio (PAPR) is taken as the generation performance optimisation parameter. By investigating the power characteristics of the SRPG, the influence of control parameters on the PAPR is studied.
Yanting Liu +4 more
wiley +1 more source
International Transactions on Electrical Energy Systems, Volume 2026, Issue 1, 2026.The increasing demand for environmentally friendly electric vehicles (EVs) highlights the necessity of efficient battery management systems (BMSs) capable of ensuring safe charging, high energy utilization, and extended battery life. Traditional control techniques such as proportional–integral (PI) and proportional–integral–derivative (PID) controllers
P. Justin Raj +4 more
wiley +1 more source
RANCANG BANGUN AC-DC FULL WAVE RECTIFIER SATU PHASA DENGAN FLYBACK DAN BUCK KONVERTER SEBAGAI PERBAIKAN FAKTOR DAYA DAN HARMONISA ARUS [PDF]
, 2010 In the electronic equipment usually requires a rectified dc voltage using diode. Given the output side of the capacitor this would cause a large current harmonics and low power factor. In this final project developed a combined flyback converter and buck
., Sutedjo, ., Yamudi, Rakhmawati, Renny
core
Electron microscopic measurement of the size of the optical focus in laser scanning microscopy [PDF]
, 2012 We describe a method for measuring the lateral focal spot size of a multiphoton laser scanning microscope (LSM) with unprecedented accuracy. A specimen consisting of an aluminum film deposited on a glass coverslip was brought into focus in a LSM and the ...
Alison McDonald +5 more
core +1 more source
Fluorescence Lifetime Imaging Techniques—A Review on Principles, Applications and Clinical Relevance
Journal of Biophotonics, Volume 18, Issue 12, December 2025.This article gives an overview of the most frequently used fluorescence‐lifetime imaging (FLIM) techniques, their capabilities and typical applications in biology and clinical studies. ABSTRACT This article gives an overview of the most frequently used fluorescence‐lifetime imaging (FLIM) techniques, their capabilities, and typical applications ...
V. I. Shcheslavskiy +5 more
wiley +1 more source
Series transistors isolate amplifier from flyback voltage [PDF]
, 1967 Circuit enables high sawtooth currents to be passed through a deflection coil and isolate the coil driving amplifier from the flyback voltage. It incorporates a switch consisting of transistors in series with the driving amplifier and deflection coil ...
Banks, W.
core +1 more source
Quadratic‐boost‐double‐flyback converter [PDF]
IET Power Electronics, 2019 Combining low‐voltage power sources with loads that require high‐voltage levels is a challenge, especially for power devices above 500 W. In this context, this study presents a new dc–dc high‐gain converter using coupled inductors. The new converter uses only one switch and output capacitors with low values.
Marcelo Flavio Guepfrih +2 more
openaire +1 more source
Steady‐state free precession for T2* relaxometry: All echoes in every readout with k‐space aliasing
Magnetic Resonance in Medicine, Volume 94, Issue 4, Page 1563-1576, October 2025.Abstract Purpose Multi‐echo gradient echo imaging is useful for a range of applications including relaxometry, susceptibility mapping, and quantifying relative proportions of fat and water. This relies primarily on long‐TR multi‐echo gradient echo sequences (FLASH), which by design isolate one signal component (i.e., echo) at a time per readout.
Peter J. Lally +7 more
wiley +1 more source
Advanced Engineering Materials, Volume 27, Issue 18, September 2025.A powerful electronic control system enables a dielectric elastomer pump to operate at resonance, matching conventional pump performance. Using self‐sensing to reconstruct load pressure dynamically, the adaptive control adjusts resonance frequency accordingly.
Matthias Baltes +3 more
wiley +1 more source
Dielectric Barrier Discharge Electrothermal Heating and Additive Manufacturing of Thermoset Parts
Advanced Materials Technologies, Volume 10, Issue 18, September 18, 2025.3D printing of thermosets is difficult due to the low yield stress of most uncured resins. However, by locally heating resin using a non‐equilibrium plasma, layers can be partially cured and printing enabled. Plasma application to a liquid epoxy/carbon nanotube composite is observed to cause rapid surface heating and oxidation of the cured layers ...
Ethan M. Harkin +3 more
wiley +1 more source