Design and implementation of a high step-up boost-fly back converter with soft switching [PDF]
In this paper a new soft switching boost-flyback converter is introduced to eliminate conventional boost-flyback converter problems in the high voltage applications. The main application of this converter is conction of PV system to the power system.
Ghasem Haghshenas +1 more
doaj
Diseño y prototipo de un precipitador electrostático
En vista del alto grado de contaminación que se presenta hoy en día, se han comenzado a buscar medidas para combatir y regular este problema. Entre estas medidas están los precipitadores electrostáticos (PES), dispositivos usados en el proceso de ...
Juan Felipe Rodríguez +3 more
doaj +1 more source
Trabalho de conclusão do projeto flyback / Flyback project completion work [PDF]
Adolfo III. Echeandia La Torre +2 more
openaire +1 more source
RANCANG BANGUN AC-DC FULL WAVE RECTIFIER SATU PHASA DENGAN FLYBACK DAN BUCK KONVERTER SEBAGAI PERBAIKAN FAKTOR DAYA DAN HARMONISA ARUS [PDF]
In the electronic equipment usually requires a rectified dc voltage using diode. Given the output side of the capacitor this would cause a large current harmonics and low power factor. In this final project developed a combined flyback converter and buck
., Sutedjo, ., Yamudi, Rakhmawati, Renny
core
Steady‐state free precession for T2* relaxometry: All echoes in every readout with k‐space aliasing
Abstract Purpose Multi‐echo gradient echo imaging is useful for a range of applications including relaxometry, susceptibility mapping, and quantifying relative proportions of fat and water. This relies primarily on long‐TR multi‐echo gradient echo sequences (FLASH), which by design isolate one signal component (i.e., echo) at a time per readout.
Peter J. Lally +7 more
wiley +1 more source
A powerful electronic control system enables a dielectric elastomer pump to operate at resonance, matching conventional pump performance. Using self‐sensing to reconstruct load pressure dynamically, the adaptive control adjusts resonance frequency accordingly.
Matthias Baltes +3 more
wiley +1 more source
Dielectric Barrier Discharge Electrothermal Heating and Additive Manufacturing of Thermoset Parts
3D printing of thermosets is difficult due to the low yield stress of most uncured resins. However, by locally heating resin using a non‐equilibrium plasma, layers can be partially cured and printing enabled. Plasma application to a liquid epoxy/carbon nanotube composite is observed to cause rapid surface heating and oxidation of the cured layers ...
Ethan M. Harkin +3 more
wiley +1 more source
On Dead-Time Optimization and Active Gate Driving in Flyback Converters With Synchronous Rectifiers
Flyback converters with synchronous rectifiers are an important topic in power electronics, given their widespread use in various applications and the focus on efficiency improvement.
Daniel A. Philipps +2 more
doaj +1 more source
High‐Isolation LCoS‐Based Optical Switch with Phase Hologram Parameter Optimization
A 1 × 9 liquid crystal on silicon (LCoS)‐based optical switch is experimentally demonstrated, revealing that the worst‐case port isolation exceeds 37 dB within the wavelength range of 1460–1540 nm. This work offers an alternative route for the development of optical switches with a large number of ports and high isolation, applicable to large‐capacity ...
Linbojie Huang +8 more
wiley +1 more source
In this paper, partial energy processing is applied to the current sharing technique for multiphase LLC resonant converters. The proposed circuit consists of an LLC resonant converter and a flyback converter, where the flyback converter is only used for ...
Yue-Lin Lee +2 more
doaj +1 more source

