Results 41 to 50 of about 509 (183)
Mokslas: Lietuvos Ateitis, 2018 Paper describes simulation results of proposed micro inverter model based on flyback converter with two transistor switches using Matlab Simulink. The aim of this research to investigate behavior of proposed model of the micro inverter based on flyback ...
Edvardas Bielskis +3 more
doaj +1 more source
IET Electrical Systems in Transportation, Volume 2026, Issue 1, 2026.Direct current (DC)–DC converters are the backbone of electric vehicle (EV) power trains, enabling efficient and bidirectional energy flow between the battery, high‐voltage (HV) DC link, and auxiliary rails under tight isolation, gain, ripple, and electromagnetic interference (EMI) constraints.
Abhilash Sakhare +3 more
wiley +1 more source
IET Power Electronics, 2021 This work is focused on a new power quality improved battery charger for electric vehicle using a two switch power factor correction (PFC) single‐ended primary inductance converter (SEPIC) at the front‐end followed by a flyback converter.
Radha Kushwaha, Bhim Singh
doaj +1 more source
Dual Switching Mode Scheme for Hybrid Boost‐Flyback/Flyback Photovoltaic Microinverter Applications
IET Power Electronics, Volume 19, Issue 1, January/December 2026.Based on an ON‐time control approach and a transition mechanism of a variable transition point, this paper presents a hybrid BCM‐BF/DCM‐F microinverter, which is operated in BCM‐BF mode for one segment of a half grid cycle and DCM‐F mode for the rest.
Feng Zhang +5 more
wiley +1 more source
IET Power Electronics, Volume 19, Issue 1, January/December 2026.To achieve both low cost and high efficiency, this article proposes a high‐power flyback PV microinverter based on a novel connection architecture and a software‐based VS control strategy. ABSTRACT For photovoltaic microinverters, power generation cost and efficiency are critical considerations. To reduce cost, this article designs a high‐power flyback
Zihao Wang +4 more
wiley +1 more source
An Accessible Large‐Language‐Model‐Based Framework for Power Converter Design
IET Power Electronics, Volume 19, Issue 1, January/December 2026.This article proposes an LLM‐based autonomous design framework that incorporates a universal circuit‐encoding method for power converter design and verification, delivering high scalability across diverse scenarios. The most dominant feature of the work is that all the designs are generated by customised generative pre‐trained transformers (GPTs ...
Quanrui Liu +7 more
wiley +1 more source
A new forward‐flyback converter without right half plane zero
IET Power ElectronicsDue to its unique features, the flyback converter is widely used to convert DC to DC power. This converter has a non‐minimum phase (NMP) dynamic behavior, which is one of its most significant disadvantages.
Sayed Mohsen Ahmadi +3 more
doaj +1 more source
Energies, 2020 This paper presents a full-bridge active-clamp forward-flyback (FBACFF) converter with an integrated transformer sharing a single primary winding. Compared to the conventional active-clamp-forward (ACF) converter, the proposed converter has low voltage ...
Jaeil Baek, Han-Shin Youn
doaj +1 more source
IEEE Open Journal of Power Electronics, 2023 This article presents a grid-connected system for renewable energy source (RES) applications. The proposed system consists of a modified switched-capacitor (SC) based multilevel inverter and a DC-DC flyback converter. By using the DC-DC flyback converter
Milad Ghavipanjeh Marangalu +5 more
doaj +1 more source
A Hybrid Grid and Photovoltaic Dual‐Input Battery Charger
IET Power Electronics, Volume 19, Issue 1, January/December 2026.This paper proposes a dual‐input battery charger (DIBC) with grid power and solar energy. The proposed DIBC consists of a boost‐type power factor correction (PFC) circuit, a high step‐down DC converter (HSDDC), and a buck switch. The grid charges the battery through the boost‐type PFC circuit combined with the HSDDC, while the solar module charges the ...
Jinn‐Chang Wu +3 more
wiley +1 more source