Results 131 to 140 of about 2,401,946 (290)

Experimental Investigation of Foam Flooding Using Anionic and Nonionic Surfactants: A Screening Scenario to Assess the Effects of Salinity and pH on Foam Stability and Foam Height. [PDF]

ACS Omega, 2022
Emami H, Ayatizadeh Tanha A, Khaksar Manshad A, Mohammadi AH.   +3 more
europepmc   +1 more source

Foam layered apparatus with foam stabilization [PDF]

Chemical technology and engineering. Proceedings.2019.№1, 2019
А. Liaposhchenko, О. Khukhryanskiy, V. Moiseev, Е. Manoilo   +3 more
openaire   +1 more source

Ti3C2Tx MXene/Silver Composite Foams For Lightweight, High‐Performance Electromagnetic Interference Shielding and Joule Heating

Advanced Materials Interfaces, EarlyView.
Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood, Mingxuan Li, Vahid Rad, Mehdi Zarei, Chen‐Yu Yeh, Masoud Soroush, Guangyong Li, Paul W. Leu   +7 more
wiley   +1 more source

Textile‐Based Capacitive Pressure Sensors Enabled by Ultrasonic Spray‐Coated Carbon Black Electrodes and Electrostatic Flocking

Advanced Materials Interfaces, EarlyView.
A 4‐layer Kevlar‐based composite is fabricated by combining ultrasonic spraying and electrostatic flocking. Carbon black dispersion is first deposited onto Kevlar fabric to create a conductive electrode. Nylon fibers are then electrostatically flocked onto the coated fabric, forming a dielectric layer.
Mengdi Chen, Hongxuan Li, Lei Shi, Fei Huang, Yuting Zhu, Wee Chen Gan, Swee Tiam Tan, Kean Aw   +7 more
wiley   +1 more source

Physicochemical properties of saponin containing Acanthophyllum laxiusculum extract: example application in foam stability and qualitative parameters for malt beverage industry. [PDF]

J Food Sci Technol, 2022
Aryan S, Mortazavian AM, Mohammadi F, Mahdavi V, Moazami N, Jazaeri S.   +5 more
europepmc   +1 more source

Adsorbent Materials for Hydrocarbons Removal by Geopolymerization of Halloysite Clay Nanotubes Filled Within Chitosan Matrix

Advanced Materials Interfaces, EarlyView.
Alkaline activation of halloysite clay nanotubes embedded in a chitosan matrix converts bionanocomposite films into porous geopolymeric materials with enhanced adsorption capacity toward hydrocarbons in both vapor and aqueous phases. The improved adsorption performance was demonstrated by the efficient capture of dodecane vapors and phenol from water ...
Alessandro Lo Bianco, Marta Giuseppina Ebbreo, Giuseppe Cavallaro, Martina Maria Calvino, Yafei Zhao, Simonpietro Agnello, Giuseppe Lazzara   +6 more
wiley   +1 more source

Sustainable foam stabilization using red mud-derived nanoparticles for enhanced oil recovery and CO2 sequestration

Scientific Reports
Foam has been widely used for enhanced oil recovery (EOR) and CO2 sequestration due to its ability to improve sweep efficiency and control gas mobility. However, foam instability poses challenges for long-term applications.
Khaled Al-Azani, Mohamed Abdrabou Hussein, Ahmed Farid Ibrahim   +2 more
doaj   +1 more source

Stability of Foams in Vacuum Drying Processes. Effects of Interactions between Sugars, Proteins, and Surfactants on Foam Stability and Dried Foam Properties. [PDF]

Foods, 2021
Kubbutat P, Leitão L, Kulozik U.
europepmc   +1 more source

Deep Eutectic Solvent‐Enhanced PEDOT: PSS/NR Foam Piezoresistive Sensor for High‐Sensitivity Wearable Devices and Sleep Monitoring Applications

Advanced Materials Interfaces, EarlyView.
A high‐performance piezoresistive foam sensor is developed by integrating natural rubber, PEDOT: PSS, and a deep eutectic solvent (DES). DES effectively detaches insulating PSS from PEDOT, dramatically amplifying electrical conductivity and sensitivity.
Shun Zhang, Jizu Ma, Peng Yu, Lei Tan, Yan Xu   +4 more
wiley   +1 more source

Smart Electrospun Nanofibers for Controlled Oil‐Water Separation

Advanced Materials Interfaces, EarlyView.
Stimuli‐responsive electrospun nanofibers are reviewed as advanced platforms for controlled oil/water separation. The effects of surface wettability, porous structure, and external stimuli, including pH, temperature, gas, and light, on separation performance are discussed.
Aynaz Sedaghatnia, Milad Babazadeh‐Mamaqani, Hossein Roghani‐Mamaqani, Donya Razzaghi, Amin Babaie, Reza Lotfi‐Mayan, Mostafa Rezaei   +6 more
wiley   +1 more source