Results 131 to 140 of about 2,863,160 (274)

Comparison of Plantar Loading Characteristics During Two Fundamental Badminton Movements Between the Individuals With Cavovarus Foot Deformity and the Ones With Normal Foot

open access: yesPhysical Treatments, 2016
Purpose: Some deformities that increase the risk of injury including cavus foot are not correctable yet and can only be limited by prevention and taking care of external causes.
Seyed Sadredin Shojaedin   +3 more
doaj  

Charge‐Polarized Ni─S4 Single‐Atom Sites Drive Selective Photoreforming of Poly(lactic acid) to Lactate and Hydrogen

open access: yesAdvanced Functional Materials, EarlyView.
Atomically dispersed Ni–S4 sites on CdS nanorods induce interfacial charge polarization, directing photogenerated electrons to H2 evolution and holes to selective ester‐bond cleavage of poly(lactic acid). Without sacrificial reagents, this charge‐coupled system produces lactate while suppressing overoxidation, achieving an H2 evolution rate of 41.74 ...
Yu Yao   +8 more
wiley   +1 more source

Effect of the Dynamic Orthotic Garment on Postural Control, and Endurance in Children with Spastic Diplegic Cerebral Palsy: A Randomized Controlled Trial

open access: yesJournal of Multidisciplinary Healthcare
Hatem A Emara,1,2,* Ahmed H Al-Johany,3 Osama A Khaled,1,4 Abdullah M Al-Shenqiti,1 Abdul Rahman H Ali,5 Marwan M Aljohani,1 Eman Sobh6,7,* 1Physical Therapy Department, College of Medical Rehabilitation Sciences, Taibah University, Medina, Saudi
Emara HA   +6 more
doaj  

Biodegradable 3D‐Printable and Coatable Antifouling Composites for Marine Applications

open access: yesAdvanced Functional Materials, EarlyView.
Marine biofouling damages submerged surfaces and raises greenhouse gas emissions. Biodegradable antifouling biocomposites were developed by hot‐mixing beeswax, Tween 80, and calcium stearate or stearic acid. Adjusting the component ratio enables processing via hot‐pressing, 3D‐printing, or dip‐coating.
Gabriele Corigliano   +17 more
wiley   +1 more source

Defect‐Free Transfer Principles for Scalable, Thin Garnet‐Based Hybrid Solid Electrolytes in Solid‐State Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Defect‐free transfer principles enable scalable fabrication of 15 µm‐thin garnet‐based hybrid solid electrolytes. Hansen solubility parameters correlate interfacial compatibility with coating, transfer, and impregnation behavior, guiding rational selection of slurry/substrate, binder/substrate, and binder/polymer electrolyte combinations.
Seul Gi Chu   +8 more
wiley   +1 more source

Lewis Acid Site Engineering in MOF‐Derived Aluminum Oxide/Carbon Composites for Dechlorination of Waste Plastic Pyrolysis Oil

open access: yesAdvanced Functional Materials, EarlyView.
Controlled carbonization of an Al‐MOF partially decomposes its linkers, exposing coordinatively unsaturated Al centers within an oxide/carbon composite. The resulting Lewis acid sites, rather than surface area, govern organochlorine capture: the composite removes chemically diverse organochlorines from waste plastic pyrolysis oil, outperforms a ...
Seong Cheon Kim   +6 more
wiley   +1 more source

The Effect of Different Types of Foot Orthoses on Foot Plantar Pressure in Subjects with Plantar Fasciitis: A Literature Review

open access: yesJournal of Rehabilitation, 2019
Objective Plantar fasciitis is a plantar fascia inflammation and one of the most common causes of heel pain, causing pain in the inner side of the heel bone.
Elahe Karami   +3 more
doaj  

Deep‐learning enabled smart insole system aiming for multifunctional foot‐healthcare applications

open access: yesExploration
Real‐time foot pressure monitoring using wearable smart systems, with comprehensive foot health monitoring and analysis, can enhance quality of life and prevent foot‐related diseases.
Yu Tian   +7 more
doaj   +1 more source

Home - About - Disclaimer - Privacy