Results 241 to 250 of about 291,405 (288)
Some of the next articles are maybe not open access.
Experimental Mechanics, 2004
A methodology to obtain the dynamic force-penetration curve of a rock specimen is presented. For this, a simple portable experimental setup is used. On one end, a hand-held hammer strikes a slender chisel. On the other end the chisel is in contact with the rock specimen into which the generated stress wave propagates.
L. Chiang
openaire +3 more sources
A methodology to obtain the dynamic force-penetration curve of a rock specimen is presented. For this, a simple portable experimental setup is used. On one end, a hand-held hammer strikes a slender chisel. On the other end the chisel is in contact with the rock specimen into which the generated stress wave propagates.
L. Chiang
openaire +3 more sources
Force penetration curve corrections in the CBR test
International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts, 1984A. Marsh
openaire +2 more sources
Effect of the granular material on the maximum holding force of a granular gripper
Granular Matter, 2020A granular gripper is a device used to hold objects by taking advantage of the phenomenon of Reynold’s dilatancy. A membrane containing a granular sample is allowed to deform around the object to be held and then vacuum is used to jam the granular ...
Juli'an M. G'omez--Paccapelo +3 more
semanticscholar +1 more source
Imaging sub-surface defects in power electronic modules using shear-force microscopy
Electronic Components and Technology Conference, 2020Recent advances in non-destructive evaluation (NDE) techniques have enhanced our understanding of failure mechanisms in power electronic systems. In this proceedings article, we demonstrate shear-force microscopy as a technique to map subsurface voids in
V. Venkatesh +2 more
semanticscholar +1 more source
Proceedings of the Institution of mechanical engineers. Part B, journal of engineering manufacture, 2023
Grinding generates a lot of heat in the grinding zone area during operation. Therefore, it is important to keep the temperature under control by using various cutting fluids to get a good ground surface quality.
Ashwani Sharma +3 more
semanticscholar +1 more source
Grinding generates a lot of heat in the grinding zone area during operation. Therefore, it is important to keep the temperature under control by using various cutting fluids to get a good ground surface quality.
Ashwani Sharma +3 more
semanticscholar +1 more source
International Journal of Crashworthiness, 2018
In this article, we extend our earlier analytical efforts of the progressive collapse of foam-filled conical frustum with the aid of a kinematically admissible folding mechanism.
Fan Yang +4 more
semanticscholar +1 more source
In this article, we extend our earlier analytical efforts of the progressive collapse of foam-filled conical frustum with the aid of a kinematically admissible folding mechanism.
Fan Yang +4 more
semanticscholar +1 more source
The International Journal of Advanced Manufacturing Technology, 2021
Xiankang Tang, Jun Zhao, Zijian Zhang
semanticscholar +1 more source
Xiankang Tang, Jun Zhao, Zijian Zhang
semanticscholar +1 more source