Results 31 to 40 of about 21,062 (311)
Advanced Engineering Materials, EarlyView.A simplified thermoplastic pultrusion model is developed to predict thermal fields in glass fiber/polyethylene terephthalate (GF/PET) composites with reduced computational cost. By combining effective material homogenization, validation against literature data, and Gaussian‐process‐based optimization, the study reveals how heating limits, pulling speed,
Elder Soares +3 more
wiley +1 more source
INVESTIGATION OF INDIRECT SOLAR DRYING OF GINGER RHIZOMES (ZINGIBER OFFICINALE): A COMPARATIVE STUDY [PDF]
Journal of Engineering Science and Technology, 2017 In this communication, an attempt has been made to investigate the drying kinetics of ginger rhizomes under natural and forced convection indirect solar drying modes.
SUNIL K. SANSANIWAL +3 more
doaj
Journal of Energy in Southern Africa, 2017 In this research paper, a simulation study has been carried out for the determination of convective heat transfer coefficients of papad under open sun drying and indoor forced convection drying modes.
Mahesh Kumar +3 more
doaj +1 more source
Enhanced visualisation of complex thermofluid data: Vertical and horizontal combined convection and microscale heat transfer cases [PDF]
, 2000 Copyright @ 2000 UITIn general, convective heat transfer is an 'n-dimensional' problem where n is well in excess of 3 for steady flows. Traditionally, the method of dimensional analysis results in a small number of dimensionless groups.
Piva, S +11 more
core
Advanced Engineering Materials, EarlyView.The present study investigates recycling of NiTi shape memory alloys via vacuum induction melting. An ingot was synthesized from elemental Ni and Ti and subjected to three subsequent remelting cycles. Remelting increases process durations and impurity levels and adversely affects microstructures and functional properties.
Sakia Sophia Noorzayee +7 more
wiley +1 more source
e-Prime: Advances in Electrical Engineering, Electronics and EnergyPhotovoltaic (PV) panels generate electricity due to photoelectric effect, harvesting solar radiation from the sun. However, the hit of photons on the upper surface of the PV panel increases its temperature, and as a result, decreases its efficiency. The
Tarek Ibrahim +5 more
doaj +1 more source
Experimental Measurements Of Air Forced Convection Through Copper Foams [PDF]
, 2012 This paper aims at investigating the air heat transfer and fluid flow through open-cells copper foam samples with different number of pores per unit of length (PPI) with constant porosity (ε=0.93) and foam core height of 40 mm.
Mancin, Simone +3 more
core +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
Advanced Engineering Materials, EarlyView.An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
SOLAR DRYING OF PEANUT PODS USING TWO DIFFERENT TYPES OF SOLAR DRYERS [PDF]
Journal of Soil Sciences and Agricultural Engineering, 2006 The objective of the present study was to investigate and evaluate two different drying methods of peanut (forced convection solar drying and natural convection solar drying) under three different layer thicknesses of (5, 10 and 15 cm) and two different ...
A. Abo ElSoud +3 more
doaj +1 more source
Energies, 2023 A comprehensive review of published works dealing with experimental studies of forced convection heat transfer of nanofluids is presented. The survey is limited to straight, smooth, and round tubes.
Janusz T. Cieśliński +1 more
doaj +1 more source