Results 41 to 50 of about 7,146 (271)
Influence of the ageing process on the resistive and reactive properties of the respiratory system
INTRODUCTION: In an increasingly old society, the study of the respiratory system changes and new techniques dedicated to older patients are of interest in physiologic studies as well as in the diagnosis of respiratory diseases.
Caio Vinicius Villalón e Tramont +4 more
doaj +1 more source
Background Alveolar recruitment maneuvers enable easily reopening nonaerated lung regions via a transient elevation in transpulmonary pressure. To evaluate the effect of these maneuvers on respiratory resistance, we used an oscillatory technique during ...
Junko Nakahira +2 more
doaj +1 more source
Forced oscilation technique and hyperinflation in COPD
AbstractForced oscillation technique (FOT) is a simple method used to measure the mechanical impedance of the respiratory system.It can be a valuable test in poorly cooperative patients (pts) and in severe COPD.Little information exists concerning its value on hyperinflation in COPD pts.The aim of this study was to analyze the correlation (corr ...
A. Borba +6 more
openaire +2 more sources
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Measurement of the direct damping derivative in roll of the two calibration missile models [PDF]
Measurement of the direct damping derivative in roll in the T-38 wind tunnel is described in this paper. The T-38 wind tunnel data for the Basic Finner Model and Modified Basic Finner model are shown.
Samardžić Marija +4 more
doaj
Interval Oscillation Criteria for Second-Order Forced Functional Dynamic Equations on Time Scales
This paper is concerned with oscillation of second-order forced functional dynamic equations of the form (r(t)(xΔ(t))γ)Δ+∑i=0nqi(t)|x(δi(t))|αisgn x(δi(t))=e(t) on time scales. By using a generalized Riccati technique and integral averaging techniques,
Shao-Yan Zhang, Qi-Ru Wang
doaj +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
Using generalized variational principle and Riccati technique, new oscillation criteria are established for forced second-order differential equation with mixed nonlinearities, which improve and generalize some recent papers in the literature.
Jing Shao, Fanwei Meng, Xinqin Pang
doaj +1 more source
Fatigue Crack Initiation and Growth in Nanocrystalline Ni at Multiple Length‐Scales
Overview of miniaturized in situ SEM fatigue setup and resultant fatigue crack growth data for nanocrystalline Ni. The presented study focuses on the analysis of fatigue crack growth rate (FCGR) in focused ion beam‐notched microcantilevers prepared from nanocrystalline (NC) Ni as a model material.
Igor Moravcik +7 more
wiley +1 more source

