Results 21 to 30 of about 32,794 (303)
Improvement of Formability of AISI 1006 Sheets by Hydroforming with Die in Square Deep Drawing [PDF]
Engineering and Technology Journal, 2023 An effort has been made to improve the formability of (1006) AISI steel alloy sheets in deep drawing of square-shaped parts with flat bases through hydroforming.
Adil Jaber, Adnan Mohammed, Karem Younis
doaj +1 more source
Contact effects in bending affecting stress and formability [PDF]
, 2010 If a strip is pulled over a curved tool there is a contact stress acting on the strip. This contact stress changes the stress state in the material, which is analysed with a simple model.
Boogaard, A.H. van den, Emmens, W.C.
core +2 more sources
Assessment of Foolad Mobarakeh ST14 Low Carbon Steel Sheet for Automobile Frames [PDF]
International Journal of Advanced Design and Manufacturing Technology, 2007 In this research formability behavior and texture of St14 low carbon steels produced by Foolad Mobarakeh plant for deep drawing application had been studied. Plate textures were characterized by X-ray Diffraction technique.
Ehsan Mohamadi +2 more
doaj
Influence of microstructure on the formability of Al-Mg6.8 alloy [PDF]
Hemijska Industrija, 2008 Formability of Al-Mg6.8 alloy has been evaluated experimentally in uniaxial tension and biaxial stretching. Three different structures developed after cold rolling and annealing in the range of temperature from 265 to 320 °C: (I) recovered dual (a + β ...
Minov Boris G. +3 more
doaj +1 more source
Research and development progress of new cold rolled sheet steels of car body
工程科学学报, 2022 The automobile industry has entered a new stage of development, with new changes in steel materials for car bodies and increasingly stringent requirements for energy conservation and emission reduction.
Guo-sen ZHU +3 more
doaj +1 more source
Optimization of conventional spinning process parameters by means of numerical simulation and statistical analysis [PDF]
, 2010 Research in sheet metal spinning has increased due to a greater demand, especially in the transportation industries, for parts with very high strength-to-weight ratios with low cost.
Essa, K, Hartley, P
core +1 more source
Numerical explicit analysis of hole flanging by single-stage incremental forming [PDF]
, 2017 The use of Single-Point Incremental Forming (SPIF) technology in hole flanging operations using multi-stages strategies have been widely studied in the last few years. However, these strategies are very time-consuming, limiting its industrial application.
Borrego Puche, Marcos +5 more
core +1 more source
Goal driven optimization of process parameters for maximum efficiency in laser bending of advanced high strength steels [PDF]
, 2015 Laser forming or bending is fast becoming an attractive option for the forming of advanced high strength steels (AHSS), due primarily to the reduced formability of AHSS when compared with conventional steels in traditional contact-based forming processes.
Dearden, Geoff +4 more
core +1 more source
Journal of Materials Research and TechnologyComposite metal sheets have found extensive applications thanks to their high corrosion and wear resistance, as well as greater strength, stiffness, and formability relative to the base sheets. Stainless steel composite sheets account for over 80% of the
S.M. Atifeh, R. Hashemi, M. Sedighi
doaj +1 more source
Crystals, 2022 The application of magnesium flat products is affected by the limited formability at room temperature and the anisotropy of the mechanical properties. The main reason for this is the underlying hexagonal crystal structure of magnesium and the development
Maria Nienaber +4 more
doaj +1 more source