Results 211 to 220 of about 975,511 (289)

High‐Rate FA‐Based Co‐Evaporated Perovskites: Understanding Rate Limitations and Practical Considerations to Overcome Their Impact

open access: yesAdvanced Functional Materials, EarlyView.
Vacuum‐based deposition is promising for perovskite solar cells to be successfully commercialized. However, co‐evaporation, the most common vapor phase deposition technique, suffers from very low deposition rates. In this work, we reveal that high deposition rates can lead to carbon flakes depositing into the perovskite absorber layers due to material ...
Thomas Feeney   +13 more
wiley   +1 more source

A primer on variational inference for physics-informed deep generative modelling. [PDF]

open access: yesPhilos Trans A Math Phys Eng Sci
Glyn-Davies A   +4 more
europepmc   +1 more source

Unveiling Aggregation‐Induced Singlet Fission in Push–Pull Diketopyrrolopyrrole Water Dispersed Nanoaggregates and Thin Films

open access: yesAdvanced Functional Materials, EarlyView.
Aggregates of diketopyrrolopyrrole dipolar and quadrupolar systems exhibit panchromatic absorption spectra extending in the entire visible range. Upon aggregation in water and in the solid state, their fluorescence is almost completely quenched and their singlet excited state lifetime is significantly shortened.
Roberto Cantoni   +10 more
wiley   +1 more source

3D Digital Light Processing of Redox‐Active Polymers for Electrochemical Applications

open access: yesAdvanced Functional Materials, EarlyView.
3D printing of electrochemically switchable conducting polymers is achieved by Digital Light Processing of redox‐active carbazole‐based polymer materials. Complex 2D and 3D architectures including dot arrays and pyramids clearly show the potential for novel 3D switchable electrochemical devices for sensors, electrochromic displays as well as 3D printed
Christian Delavier   +4 more
wiley   +1 more source

Charge transfer governed interlayer magnetic coupling and symmetry breaking in a van der Waals magnet. [PDF]

open access: yesNat Commun
Hong C   +10 more
europepmc   +1 more source

High‐Yield Synthesis of Fe‐NC Electrocatalysts Using Mg2+ Templating and Schiff‐Base Porous Organic Polymers

open access: yesAdvanced Functional Materials, EarlyView.
Fe─NC porous oxygen reduction electrocatalysts are prepared employing a 2,4,6‐Triaminopyrimidine‐based porous organic polymer, a Mg2+ Lewis acid, and a low‐temperature cation exchange protocol. Using the polymer precursor achieves high pyrolysis yields and results in atomically dispersed FeNx sites. The resulting catalysts feature hierarchical porosity
Eliot Petitdemange   +11 more
wiley   +1 more source

Unconventional hysteresis due to time-reversal symmetry breaking superconductivity in RbV<sub>3</sub>Sb<sub>5</sub>. [PDF]

open access: yesNat Commun
Wang S   +15 more
europepmc   +1 more source

‘Oxygen Bound to Magnesium’ as High Voltage Redox Center Causes Sloping of the Potential Profile in Mg‐Doped Layered Oxides for Na‐Ion Batteries

open access: yesAdvanced Functional Materials, EarlyView.
Na‐ion batteries ‐ Impact of doping on the oxygen redox: The sloping potential of NaMg0.1Ni0.4Mn0.5O2 above 4.0 V is caused by a new redox center (arising from the ‘O bound to Mg’), having a higher potential but being more irreversible compared to the ‘O bound to Ni’.
Yongchun Li   +12 more
wiley   +1 more source

Home - About - Disclaimer - Privacy