Results 21 to 30 of about 4,653,376 (220)
High Temperature Thermal Properties of Bentonite Foundry Sand
Archives of Foundry Engineering, 2015 The paper presents results of measuring thermal conductivity and heat capacity of bentonite foundry sand in temperature range ambient - 900°C. During the experiments a technical purity Cu plate was cast into the green-sand moulds.
Krajewski P.K. +3 more
doaj +1 more source
Ultrasound Wave Attenuation of Grain Refined High – Zinc Aluminium Sand-cast Alloys
Archives of Foundry Engineering, 2015 The paper presents results of measuring attenuation coefficient of the Al-20 wt.% Zn alloy (AlZn20) inoculated with different grain refiners. During experiments the melted alloys were doped with Al-Ti3-C0.15 refining master alloy.
Krajewski W.K. +3 more
doaj +1 more source
2023 Eagle Foundry Co. total enclosure verification test protocol
, 2023 prepared for: Eagle Foundry Co. ; prepared by: Bison Engineering, Inc.Title from PDF cover (viewed on March 23, 2023)."Oregon Department of Environmental Quality Air Contaminant Discharge Permit No.
core
Thermal Properties of Foundry Mould Made of Used Green Sand
Archives of Foundry Engineering, 2016 The paper presents results of measuring heat diffusivity and thermal conductivity coefficients of used green foundry sand in temperature range ambient − 600 °C.
Krajewski P.K., Piwowarski G., Buraś J.
doaj +1 more source
2023 Eagle Foundry air arc and finish end areas PTE verification report
, 2023 prepared for: Eagle Foundry Co. ; prepared by: Bison Engineering, Inc."Oregon Department of Environmental Quality Air Contaminant Discharge Permit No.
core
Analysis of Influence of Sand Matrix on Properties of Moulding Compounds Made with Furan Resin Intended for 3D Printing [PDF]
Archives of Foundry EngineeringBinder jetting (BJ) sand printing is a 3D printing process in which a sand mould or sand core is produced from an STL file. A single layer of a sand matrix consisting of one or more grains in height of sand is applied to a worktable, and then a liquid ...
D.R. Gruszka +3 more
doaj +1 more source
Metallurgy and Foundry Engineering
, 2010 Production technology of investment casting involves transmitting the elements of shape, dimensions and properties by filling in the appropriate liquid metal ceramic forms reproduced by a model made of wax removed by melting it. The manufacturing process
Kamińska, Jadwiga +2 more
core +2 more sources
2023 Eagle Foundry Co. inlet/outlet baghouse emission factor verification test protocol
, 2023 prepared for: Eagle Foundry Co. ; prepared by: Bison Engineering, Inc.Title from PDF cover (viewed on February 1, 2023)."Oregon Department of Environmental Quality Air Contaminant Discharge Permit No.
core
The Effect of Grain-refinement on Zn-10Al Alloy Damping Properties
Archives of Foundry Engineering, 2014 The paper is devoted to grain-refinement of the medium-aluminium zinc based alloys (MAl-Zn). The system examined was sand cast Zn- 10 wt. %. Al binary alloy (Zn-10Al) doped with commercial Al-3 wt. % Ti - 0.15 wt.
Piwowarski G. +3 more
doaj +1 more source
Technical Transactions, 2023 This article presents the first part of the research on the production of large-size castings, such as bottom plates and counterweights produced in the Krakodlew S.A. foundry.
Guzik Edward +5 more
doaj +1 more source