Results 91 to 100 of about 24,882 (266)

Robust Spot Melting by 3D Spot Arrangements in Electron Beam Powder Bed Fusion

Advanced Engineering Materials, EarlyView.
This work proposes an approach to replace separately melted contours for spot melting in electron beam powder fusion. Adapting the spot arrangements close to the contour combined with stacking yields a comparable surface quality without the inherent challenges of separate contours, as demonstrated, by electron optical images and roughness measurements.
Tobias Kupfer, Lukas Spano, Sebastian Pohl, Carolin Körner, Matthias Markl   +4 more
wiley   +1 more source

Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys

Advanced Engineering Materials, EarlyView.
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak, Olha Zvirko, Rostyslav Leshchak, Hryhoriy Nykyforchyn   +3 more
wiley   +1 more source

A Novel Piecewise Frequency Control Strategy Based on Fractional-Order Filter for Coordinating Vibration Isolation and Positioning of Supporting System. [PDF]

Sensors (Basel), 2020
Tao Y, Jiang W, Han B, Li X, Luo Y, Zeng L.   +5 more
europepmc   +1 more source

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

Advanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter, Andreas Bezold, Johan Westraadt, Katharina Fiegl, Subham Chattoraj, Benjamin Wahlmann, Carolin Körner, Michael Mills, Mathias Göken, Steffen Neumeier   +9 more
wiley   +1 more source

Direct Metal Deposition of Graphene–Ti28Nb35.4Zr Matrix Composites With Enhanced Mechanical, Corrosion, and Biocompatibility Properties for Bone Implants

Advanced Engineering Materials, EarlyView.
Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir, Jixing Lin, Yuncang Li, Li Zhu, Paul F. A. Wright, Cuie Wen   +5 more
wiley   +1 more source

Dynamic Behaviors and the Equivalent Realization of a Novel Fractional-Order Memristor-Based Chaotic Circuit

Complexity, 2018
This paper proposed a novel fractional-order memristor-based chaotic circuit. A memristive diode bridge cascaded with a fractional-order RL filter constitutes the generalized fractional-order memristor.
Ningning Yang, Cheng Xu, Chaojun Wu, Rong Jia, Chongxin Liu   +4 more
doaj   +1 more source

In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy

Advanced Engineering Materials, EarlyView.
A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal, Tae‐Hyeok Kang, Pyuck‐Pa Choi, Subin Lee, Christoph Kirchlechner   +4 more
wiley   +1 more source

Fixed-Time Robust Fractional-Order Sliding Mode Control Strategy for Grid-Connected Inverters Based on Weighted Average Current

Energies
To address the issues of high computational load and slow dynamic performance in traditional fractional-order sliding mode control for LCL-type grid-connected inverters, this paper proposes a fixed-time robust fractional-order sliding mode control ...
Wenbin Song, Yanfei Dong, Guofeng He, Zichun Zhou   +3 more
doaj   +1 more source

Optimal control and parameters design for the fractional-order vehicle suspension system

Journal of Low Frequency Noise, Vibration and Active Control, 2018
In this paper the optimal control and parameters design of fractional-order vehicle suspension system are researched, where the system is described by fractional-order differential equation.
Hao You, Yongjun Shen, Haijun Xing, Shaopu Yang   +3 more
doaj   +1 more source

Inactivating SARS‐CoV‐2 Virus with MOF‐Composites as Smart Face Masks

Advanced Functional Materials, EarlyView.
In situ preparation and functionalization of MOF@Cotton fabrics as smart face masks for the immobilization of proteins and inactivation viruses, such as SARS‐CoV‐2. Abstract The significant impact of the SARS‐CoV‐2 (COVID‐19) pandemic outbreak on people's lives has highlighted the urgent need for effective personal protective equipment.
Romy Ettlinger, Aamod V. Desai, Hau Lam Jody Cheong, Louise L. Major, Terry K. Smith, Aaron B. Naden, Jane Hilton, Catherine S. Adamson, A. Robert Armstrong, Russell E. Morris   +9 more
wiley   +1 more source