Results 71 to 80 of about 7,770 (217)
Fatigue &Fracture of Engineering Materials &Structures, Volume 49, Issue 12, Page 5246-5264, December 2026.ABSTRACT The present study proposes a combined approach of infrared thermography and 3D XFEM numerical models for crack process investigation in mechanical components such as gears. Over the years, fatigue crack analysis based on energy dissipations in the form of heat generated during fatigue tests has been widely reported, although mainly limited to ...
Luca Corsaro +3 more
wiley +1 more source
Experimental Study on the Fatigue Behavior of Ti‐6Al‐4 V Bolted Joints Containing Burrs
Fatigue &Fracture of Engineering Materials &Structures, Volume 49, Issue 12, Page 5464-5477, December 2026.ABSTRACT One‐way assembly accelerates aerospace manufacturing operations but risks leaving drilling burrs within mechanical joints. The detrimental impact of burrs on fatigue strength is widely recognized in the literature, but the mechanisms driving this “knock‐down” remain unclear. This investigation focused on mechanically fastened Ti‐6Al‐4 V single‐
Santiago Frutos Taravillo +6 more
wiley +1 more source
Analisis Kegagalan Pada Bottle Gripper Dengan Mengunakan Metode Fractography (Studi Kasus Pt.Amarta Indah Otsuka) [PDF]
, 2012 Terjadi kegagalan dari sebuah komponen dalam suatu mesin produksi minuman (PT. Amerta Indah Otsuka) bottle gripper yang merupakan komponen dari suatu mekanisme yang bertugas untuk mengangkat dan memindahkan bottle yang telah terisi.
Azarya,ArdyaJulio
core
Application of Bone Fractography to a Medical Examiner Sample: A Case Series
, 2018 This case study review assesses the applicability of forensic fractography of bone to forensic casework through the evaluation of four blunt-trauma cases.
Christensen, Angi M., Love, Jennifer C.
core +1 more source
Some studies on the influence of stress ratio and test temperature on X-ray fractography observations in C45 steel specimens [PDF]
, 1996 This paper deals with additional ¿X-ray fractography¿ observations made on C45 steel, subsequent to the earlier work [K. Rajanna, B. Pathiraj and B. H. Kolster, Fatigue fracture surface analysis in C45 steel specimens using X-ray fractography.
K. Rajanna +5 more
core +1 more source
, 1996 The utilization of fractography to determine crack origins as well as the mechanisms of crack propagation is an established method in failure analysis.
Lüthi, Thomas (author) +2 more
core +1 more source
Tufting‐Based Manufacturing Method for High‐Performance 3D Composite Lap Joints
Polymer Composites, Volume 47, Issue 21, Page 19851-19870, 10 November 2026.Graphical abstract illustrating the manufacturing process of a tufted non‐crimp preform lap joint, fractographic characterisation and comparative mechanical performance evaluation. ABSTRACT This study presents a tufting‐enabled through‐thickness reinforcement approach for enhancing the performance of 3D composite lap joints manufactured using resin ...
J. Ahmed +3 more
wiley +1 more source
Investigating iodine-induced stress corrosion cracking of zirconium alloys using quantitative fractography [PDF]
, 2020 Pellet Cladding Interaction (PCI) is a fuel failure phenomenon that limits power manoeuvrability of light water nuclear reactors with Iodine-Stress Corrosion Cracking (I-SCC) the most commonly hypothesised cause.
Frankel, Philipp; id_orcid +3 more
core +1 more source
Journal of Applied Polymer Science, Volume 143, Issue 41, November 5, 2026.Whole‐tire reclaimed rubber is upgraded with wood sawdust, a carpentry by‐product available at no cost, across loadings from 0 to 20 wt%. At 5 wt%, tensile strength, elongation, hardness, viscosity, and water absorption all stay within commercial specification, and real factory data show an annual production saving near $62,000 with no capital ...
Mohammed S. Matar +3 more
wiley +1 more source
Materials Research, 2002 A nuclear reactor pressure vessel steel was submitted to different annealing heat treatments aimed at simulating neutron irradiation damage. The obtained microstructures were mechanically tested with subsequent metallographic and fractographic ...
Tarpani José R. +3 more
doaj