Results 211 to 220 of about 1,391,337 (356)
Advanced Engineering Materials, EarlyView.The release of foulers from protective marine coatings is determined by several interrelated material properties, including the strength of Young's modulus, the flexibility of chain segments, the surface free energy, and the magnitude of hydrodynamic stress.
Johann C. Schaal +2 more
wiley +1 more source
Shortening of Right Humerus and Left Thigh Due to Unobserved Fractures in Early Life (Infantile Scurvy ?) [PDF]
, 1910 Harold Burrows
openalex +1 more source
Management and long-term outcome of pelvic fractures: a retrospective study of 43 cats [PDF]
, 2017 Bookbinder PE +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.It is demonstrated that laser‐induced graphene (LIG) can be encapsulated while preserving its electrical conductivity and enhancing its mechanical properties. Unlike previous encapsulation attempts, the optimal conditions described here result in sheet resistance of ≈2 Ω sq−1, resistance increase of only 5% upon encapsulation, and vastly improved ...
Fatemeh Bayat +3 more
wiley +1 more source
Bilateral Traumatic Scaphoid Fracture Managed Surgically with Headless Compression Screw: A Case Report with Review Literature. [PDF]
J Orthop Case RepChoudhary L +5 more
europepmc +1 more source
Development of SiC Nanocomposites Using Direct Ink Writing Process
Advanced Engineering Materials, EarlyView.Herein, feedstock inks containing polycarbosilane and various concentrations of SiC nanoparticles (SiCnp) are investigated for fabricating ceramic matrix composites using a DIW 3D printing process. Characterization results from physical measurement, microstructure analysis, and thermal and flexural testing suggested that high‐performance CMC samples ...
Jinchen Han +5 more
wiley +1 more source
Linking Heat Treatment to Plastic Deformation in Pearlitic Steels Through Mesoscale Modeling
Advanced Engineering Materials, EarlyView.Surface wear on rail and wheel steels results from surface deformation during use. This research uses mathematical models to forecast the plastic behavior of pearlitic steels, connected to the microstructure formed during heat treatment. While the cooling rate impacts the steels’ strength, the size of prior austenite grains and blocks does not ...
Saham Sadat Sharifi +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Sludge phases with brittle fracture behavior form in AlMgSi alloys with high concentrations of alloying elements and negatively influence their ductility. The phase type mainly depends on the Si content and the concentration of minor alloying elements like Fe, Mn, Cr, and Mo strongly influences the number of sludge particles. The need for sustainable
Dominik Steinacker +3 more
wiley +1 more source
Improved Strength and Corrosion Resistance of Ti–50Zr Alloy Through Heat Treatment
Advanced Engineering Materials, EarlyView.This work systematically analyzes the effects of heat treatment on mechanical properties and corrosion behavior of Ti‐50Zr alloy produced via vacuum arc melting. Microstructure transforms from coarse lamellar α phase in as‐cast condition to fine and uniformly distributes acicular α′ phase in heat‐treatment state.
Yuhua Li +7 more
wiley +1 more source