Results 21 to 30 of about 37,000 (232)
Energies, 2023 To study the influence of the axial installation deviation of the runner on the hydraulic axial force of the 1000 MW Francis turbine unit, geometric models of the full flow passage of the Francis turbine with the runner sinking in the axial direction by ...
Yongsheng Liu +6 more
doaj +1 more source
Optimized Reduction in Draft Tube Pressure Pulsation for a Francis Turbine [PDF]
Journal of Applied Fluid MechanicsAs a core component of hydroelectric power generation, the stable and safe operation of the Francis turbine is very important for the operation of the project. Therefore, attention must be paid to the problem of pressure pulsation in the Francis turbine.
J. Lu, R. Tao
doaj +1 more source
Applied Sciences, 2023 This paper focuses on a 1000 MW Francis turbine and conducts a numerical analysis of the entire flow passage using computational fluid dynamics (CFD) under steady-state conditions.
Yifan Wang +6 more
doaj +1 more source
A framework for developing engineering design ontologies within the aerospace industry [PDF]
, 2014 This paper presents a framework for developing engineering design ontologies within the aerospace industry. The aim of this approach is to strengthen the modularity and reuse of engineering design ontologies to support knowledge management initiatives ...
Sanya, I. O., Shehab, Essam
core +1 more source
CFD approach to analysis of the flow characteristics of a high-pressure francis turbine [PDF]
, 2019 З ростом обчислювальної механіки віртуальні гідравлічні машини стають все більш реалістичними, дають можливість визначити незначні деталі потоку, що в свою чергу неможливо отримати при тестуванні моделей.
Миронов, Вадим Костянтинович +2 more
core +1 more source
Experimental Flow Performance Investigation of Francis Turbines from Model to Prototype
Applied SciencesInvestigating the flow performance of Francis turbines from model to prototype is a complex but essential process for ensuring reliable and efficient turbine operation in hydropower plants.
Baig Mirza Umar +2 more
doaj +1 more source
Innovation of Pump as Turbine According to Calculation Model for Francis Turbine Design
Energies, 2021 The effective utilization of micro hydropower sources is often realized through the use of pumps as turbines (PAT). The efficiency of PAT is about the same as that of the original pump. A further increase in efficiency and power output can be achieved by
Martin Polák
doaj +1 more source
Applied SciencesFrancis turbines, being widely used in hydropower plants, operate under different loads which significantly affect their hydraulic characteristics and structural dynamics.
Xingxing Huang +4 more
doaj +1 more source
Energies, 2022 The Francis hydro-turbine is a typical nonlinear system with coupled hydraulic, mechanical, and electrical subsystems. It is difficult to understand the reasons for its operational failures, since the main cause of failures is due to the complex ...
Andrey Achitaev +3 more
doaj +1 more source
Ocean energy:the wave of the future [PDF]
, 2008 The power point presentation discussed the developing technology of ocean energy with design convergence on tidal but not on wave. Today's technologies will help solve the immediate needs, but we need to work hard nurturing tomorrow's low carbon ...
Aggidis, George A.
core +1 more source