Influence of an Argon/Silane Atmosphere on the Temperature of a Thermal Plasma
The influence of a silane‐doped argon atmosphere on the chemical composition and temperature of a thermal nontransferring argon plasma is investigated using optical emission spectroscopy. As a result of the high amount of free electrons resulting from the stepwise ionization and dissociation of the silane molecule, even a silane addition of 0.01 vol ...
Lena Kreie +4 more
wiley +1 more source
Zero-bit self-adaptive spectral noise shaping for speech and audio coding. [PDF]
Omidi Piralideh N +2 more
europepmc +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
High-Coherence, Physically Separable Dual-Frequency Fiber Laser Based on Bidirectional Dual-Path Ring Cavity. [PDF]
Li S, Ji B, Zhu F, Gan Y, Li Z, Wen Q.
europepmc +1 more source
Application of Raman and Photoluminescence Spectroscopy to MgO‐C Refractories
Visible to near infrared luminescence of MgO is studied on MgO‐C bricks and nominally pure MgO powder, with focus on two similar sharp high‐intensity signals, at 699 and 871 nm, each surrounded by symmetrical sidebands. The nature of these sidebands is investigated by temperature‐dependent spectroscopic measurements, confirming phonon involvement by ...
Julia Richter +5 more
wiley +1 more source
300-GHz Photonics-Aided Wireless 2 × 2 MIMO Transmission over 200 m Using GMM-Enhanced Duobinary Unsupervised Adaptive CNN. [PDF]
Jiang L, Yu J, Zhang Q, Zhou W, Zhu M.
europepmc +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
High-temporal resolution metabolic connectivity resolved by component-based noise correction. [PDF]
Reed MB +16 more
europepmc +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Adaptive Resonance Demodulation for Bearing Fault Diagnosis via Spectral Trend Reconstruction and Weighted Logarithmic Energy Ratio. [PDF]
Feng Q +6 more
europepmc +1 more source

