Results 1 to 10 of about 4,488,266 (309)

Fluid Degradation Measurement Based on a Dual Coil Frequency Response Analysis [PDF]

open access: yesSensors, 2020
Electrical industry uses oils for cooling and insulation of several machines, such as power transformers. In addition, it uses water for cooling some synchronous generators. To avoid malfunctions in these assets, fluid quality should be preserved.
Jose M. Guerrero   +3 more
doaj   +2 more sources

Online Frequency Response Analysis of Electric Machinery through an Active Coupling System Based on Power Electronics [PDF]

open access: yesSensors, 2021
This paper presents an innovative concept for the online application of Frequency Response Analysis (FRA). FRA is a well known technique that is applied to detect damage in electric machinery.
Wilson Cesar Sant’Ana   +9 more
doaj   +2 more sources

Detection of Failures in Metal Oxide Surge Arresters Using Frequency Response Analysis [PDF]

open access: yesSensors, 2023
This work presents an innovative application of Frequency Response Analysis (FRA) in order to detect early degradation of Metal Oxide Surge Arresters (MOSAs). This technique has been widely used in power transformers, but has never been applied to MOSAs.
Tiago Goncalves Zacarias   +9 more
doaj   +2 more sources

Frequency Response Analysis of Buck-Boost Inverter

open access: yesMìkrosistemi, Elektronìka ta Akustika, 2019
The paper deals with processes analysis in inverter circuits. These processes are described by differential equations with periodical coefficients. Since control signals and voltages operating in an inverter circuit are independent theirs frequencies are
Igor Yevheniiovych Korotyeyev
doaj   +3 more sources

Efficient Structural Dynamic Analysis Using Condensed Finite Element Matrices and Its Application to a Stiffened Plate

open access: yesJournal of Marine Science and Engineering, 2022
In this study, we propose effective formulations for modal, frequency response, and transient analyses using condensed matrices of the finite element (FE) model.
Do-Hyun Ko, Seung-Hwan Boo
doaj   +1 more source

Fast Vibration Reduction Optimization Approach for Complex Thin-Walled Shells Accelerated by Global Proper Orthogonal Decomposition Reduced-Order Model

open access: yesApplied Sciences, 2022
A fast vibration reduction optimization approach accelerated by the global proper orthogonal decomposition (POD) reduced-order model (ROM) is proposed, aiming at increasing the efficiency of frequency response analysis and vibration reduction ...
Yongxin Shi   +5 more
doaj   +1 more source

Empirical Modeling of 2-Degree-of-Freedom Azimuth Underwater Thruster Using a Signal Compression Method

open access: yesApplied Sciences, 2021
This paper presents an empirical modeling of a 2-Degree-of-Freedom (DoF) azimuth thruster using the signal compression method. The thruster has a gimbal mechanism with two servo motors and generates thrust in arbitrary directions.
Cheol-Su Jeong   +3 more
doaj   +1 more source

Research on the Shock Response Characteristics of a Threaded Connection Using the Thin-Layer Element Method

open access: yesApplied Sciences, 2021
Nonlinear factors such as the contact stiffness and friction damping at the threaded interface of a projectile–fuse system significantly affect the dynamic response characteristics.
A’min Yan   +4 more
doaj   +1 more source

Interpretation of Frequency Response Analysis for Fault Detection in Power Transformers

open access: yesApplied Sciences, 2021
Frequency response analysis (FRA) is a method of monitoring a power transformer’s mechanical integrity. However, identifying the type of fault and its severity by comparing measured responses is still challenging and mostly relies on personnel expertise.
Salem Mgammal Al-Ameri   +5 more
doaj   +1 more source

Proof of Concept for the Detection of Local Pressure Marks in Prosthesis Sockets Using Structural Dynamics Measurement

open access: yesSensors, 2021
The wear comfort of a prosthesis is of great importance for amputee patients. The wear comfort can be affected by changes in the interface between the residual limb and prosthesis socket, which can be caused by time-dependent volume fluctuations of the ...
Constanze Neupetsch   +5 more
doaj   +1 more source

Home - About - Disclaimer - Privacy