Results 41 to 50 of about 1,362,717 (268)

The Development of Environmentally Friendly Technologies of Using Coals and Products of Their Enrichment in the Form of Coal Water Slurries

open access: yesE3S Web of Conferences, 2017
The article presents the current state of the technology for production and combustion of fuel coal water slurries in Russia and foreign countries.
Murko Vasily, Hamalainen Veniamin
doaj   +1 more source

Aerated atomization of coal-water slurry fuels [PDF]

open access: yes, 1988
In order to observe the effects of rheology on the atomization of highly viscous non-Newtonian liquids, glycerin-water solutions and cellulose-glycerin-water solutions have been atomized. In this series of tests, nozzle pressure, air-liquid ratio and liquid viscosity were altered, and the effects were observed. 14 figs.
Buckner, H.N.   +2 more
openaire   +4 more sources

Study of the Weber number impact on secondary breakup of droplets of coal water slurries containing petrochemicals

open access: yesFuel, 2019
The research presents the numerical modeling findings of the secondary breakup of droplets of coal water slurries containing petrochemicals (CWSP). The modeling method of the secondary droplet breakup is based on the VOF method for interface resolution ...
A. V. Minakov   +4 more
semanticscholar   +1 more source

POM‐Based Water Splitting Catalyst Under Acid Conditions Driven by Its Assembly on Carbon Nanotubes

open access: yesAdvanced Materials, EarlyView.
A newly‐engineered POM‐based electrocatalyst incorporating non‐innocent counter cations exhibits fast kinetics for either the OER or HER under strongly acidic conditions (1 m H2SO4), depending on whether it is assembled on carbon nanotubes (1@CNT) or physically mixed with them (1/CNT). In water‐splitting tests using a two‐electrode setup, these systems
Eugenia P. Quirós‐Díez   +8 more
wiley   +1 more source

Effect of Atomic Layer Deposition of Ultra‐Thin Oxide on Reactivity and Durability of Perovskite Oxygen Electrodes

open access: yesAdvanced Materials, EarlyView.
This table of contents illustrates that the mechanism for mitigating Sr segregation depends strongly on the chemistry of the coating layer. HfO2 electrostatically stabilizes the surface by lowering the surface oxygen vacancies, which serve as the driving force for Sr migration. On the other hand, Al2O3 and Fe2O3 react with segregated Sr to form Sr‐Al‐O
Jongsu Seo   +8 more
wiley   +1 more source

Influence of rheology in the filtration of leach slurry generated by alkaline pressure leaching of a limestone ore

open access: yesCleaner Chemical Engineering, 2022
The Nuclear Power Plant, which uses uranium as a fuel, is considered as a clean source of energy with low carbon footprint and less environmental damage.
Md Serajuddin   +2 more
doaj   +1 more source

Photocatalytic Water Splitting on the Lunar Surface: Prospects for In Situ Resource Utilization

open access: yesAdvanced Materials Interfaces, EarlyView.
Water has been found in craters on the moon nearby locations which are illuminated >80% of the time. Photocatalysis uses energy from sunlight to drive chemical reactions such as water splitting to produce oxygen and hydrogen. It is a scalable technology that requires lighter equipment and utilizes resources available on the moon. ABSTRACT The discovery
Ranjani Kalyan   +6 more
wiley   +1 more source

Preparation and investigation of coal slurry fuel blended with industrial wastewater for use in thermal power generation

open access: yesSukkur IBA Journal of Emerging Technologies, 2019
Coal is an important and vital fossil fuel. It has been underutilized due to its complex mining procedures, transportation constraints and environmental impacts.
Mueed Akhtar
doaj   +1 more source

Investigation of agglomeration and sedimentation of PEFC electrode slurries by a laminated microfluidic device

open access: yesNihon Kikai Gakkai ronbunshu, 2020
A film-laminated microfluidic device was fabricated to analyze an electrode slurry used to form a porous electrode of polymer electrolyte fuel cells, and sorting of particles in the slurry was demonstrated.
Takahiro SUZUKI   +4 more
doaj   +1 more source

Three‐Dimensional Printed Microarchitected Hierarchically Porous Biodegradable PLA/S/CNT Nanocomposite Electrodes for High‐Performance Lithium–Sulfur Batteries

open access: yesAdvanced Materials Technologies, EarlyView.
Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy