Results 1 to 10 of about 274,755 (208)
Controlled Transition Full-Bridge Hybrid Multilevel Converter With Chain-Links of Full-Bridge Cells [PDF]
This paper proposes a controlled transition full-bridge (CTFB) hybrid multilevel converter (HMC) for medium and high voltage applications. It employs a full-bridge cell chain-link (FB-CL) between the two legs in each phase to generate multilevel bipolar output voltage.
Li, Peng +3 more
openaire +4 more sources
Modeling and Enhanced Control of Hybrid Full Bridge–Half Bridge MMCs for HVDC Grid Studies [PDF]
Modular multilevel converters (MMCs) are expected to play an important role in future high voltage direct current (HVDC) grids. Moreover, advanced MMC topologies may include various submodule (SM) types.
Ricardo Vidal-Albalate, Jaume Forner
doaj +3 more sources
A fast response full bridge power factor corrector [PDF]
A fast response full-bridge power factor corrector (FBPFC) is presented in this paper. The power converter is combined by two interleaved boost cells and a conventional full bridge power converter. As the interleaving technique is applied, the input ripple current of the FBPFC is reduced. Experimental result shows that the maximum power factor is 0.98,
Chan, CH, Pong, MH
openaire +4 more sources
A novel ZVS full-bridge converter [PDF]
Conventional soft switching techniques are promising for improvement of efficiency in full bridge converters. However, efficiency of converters with employing such techniques is restricted due to narrow range of zero voltage switching (ZVS). In such situation, several methods have been proposed in the literature to cope with wide range of ZVS from no ...
Nasir, , Cobb, Jonathan E.
openaire +3 more sources
Comparison between Phase-Shift Full-Bridge Converters with Noncoupled and Coupled Current-Doubler Rectifier [PDF]
This paper presents comparison between phase-shift full-bridge converters with noncoupled and coupled current-doubler rectifier. In high current capability and high step-down voltage conversion, a phase-shift full-bridge converter with a conventional ...
Cheng-Tao Tsai +2 more
doaj +2 more sources
With the expansion of E-mobility technology, the demand for Medium-Voltage (MV) Electric Buses (E-buses) charging infrastructure has significantly increased.
Mena ElMenshawy, Ahmed Massoud
doaj +1 more source
A Novel Isolated DC–DC Converter for High Step-Down Applications
This paper proposes a new isolated high step-down DC–DC converter based on the phase-shift full-bridge converter. The proposed converter has some properties very suitable for high step-down applications including a high step-down ratio, low ...
Van-Cuong Bui +5 more
doaj +1 more source
The conventional resonant inductor–inductor–capacitor (L2C) DC–DC converters have the major drawbacks of poor regulation, improper current sharing, load current ripples, conduction losses, and limiting the power levels to operate at higher loads for ...
Rajanand Patnaik Narasipuram +1 more
doaj +1 more source
A full-bridge diode-clamped multilevel LLC resonant converter suitable for power conversion systems that use high input voltage, such as railway vehicles, is proposed in this paper. In order to eliminate the voltage deviations of the capacitors connected
Min-Sup Song, Jae-Bum Lee
doaj +1 more source
Soft-Switching Full-Bridge DC-DC Converter with Energy Recovery Capacitor Snubber
This paper describes a high-frequency soft-switching dc-dc converter with a simple energy recovery capacitor snubber on the secondary side. The presented dc-dc full-bridge converter with the energy recovery snubber removes the main drawbacks of the ...
Marek Pastor +3 more
doaj +1 more source

