Results 71 to 80 of about 87,022 (241)

Trends in Dermatopolymyositis Mortality, 1999–2022: A Nationwide Population‐Based Study, United States

open access: yesArthritis Care &Research, EarlyView.
We report the national burden of dermatopolymyositis mortality over the past quarter century using the US national vital statistics data. Age‐standardized mortality rates for dermatopolymyositis decreased at an annual rate of 3.8% each year, which was higher than the annual percent decrease for deaths from all other causes.
Elizabeth Matz, Ram R. Singh
wiley   +1 more source

Hopfield Neural Networks for Online Constrained Parameter Estimation With Time‐Varying Dynamics and Disturbances

open access: yesInternational Journal of Adaptive Control and Signal Processing, EarlyView.
This paper proposes two projector‐based Hopfield neural network (HNN) estimators for online, constrained parameter estimation under time‐varying data, additive disturbances, and slowly drifting physical parameters. The first is a constraint‐aware HNN that enforces linear equalities and inequalities (via slack neurons) and continuously tracks the ...
Miguel Pedro Silva
wiley   +1 more source

MODERN WEB ON THE EXAMPLE OF CREATING A SIMPLE TASK MANAGER

open access: yesInternational Journal of Advanced Studies, 2018
The article describes the process of creating a web application “Task Manager”. The development uses modern web tools. Directly, in the article itself, a complete analysis of the writing of the simplest task manager is carried out using the full list of ...
Ilnar Vasilovich Badykov   +1 more
doaj   +1 more source

Revisiting Stability Criteria in Ball‐Milled High‐Entropy Alloys: Do Hume–Rothery and Thermodynamic Rules Equally Apply?

open access: yesAdvanced Engineering Materials, Volume 27, Issue 6, March 2025.
The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez   +5 more
wiley   +1 more source

Bistable Mechanisms 3D Printing for Mechanically Programmable Vibration Control

open access: yesAdvanced Engineering Materials, EarlyView.
This work introduces a 3D‐printed bistable mechanism integrated into tuned mass dampers (TMDs) for mechanically adaptive passive vibration suppression. Through optimized geometry, the bistable design provides adaptable vibration reduction across a broad range of scenarios, achieving effective vibration mitigation without complex controls or external ...
Ali Zolfagharian   +4 more
wiley   +1 more source

AVO reflectivity and pre-stack seismic impedance inversion for gas sand channel detection at South Abu El Naga Field, Onshore Nile Delta, Egypt

open access: yesScientific Reports
The reservoir compartment is a major uncertainty at South Abu El Naga gas field, onshore Nile Delta, Egypt. The objective of this study is to detect Abu Madi gas sand reservoir using different pre-stack inversion techniques such as AVO reflectivity ...
Nourhan Ahmed Al-Ashqar   +3 more
doaj   +1 more source

Green Hydrogen Production with 25 kW Alkaline Electrolyzer Pilot Plant Shows Hydrogen Flow Rate Exponential Asymptotic Behavior with the Stack Current

open access: yesHydrogen
Green H2 production using electrolyzer technology is an emerging method in the current mandate, using renewable-based power sources integrated with electrolyzer technology.
Debajeet K. Bora
doaj   +1 more source

Adjustment of Coatings Morphology and Particle Distribution of Layered Silicates by Freeze‐Drying for Improved Gas Barriers

open access: yesAdvanced Engineering Materials, EarlyView.
Freeze‐drying of layered silicate is the key to get coatings with superior gas barrier. Freeze‐drying of layered silicates modified with dodecylamine (DDA) is a highly effective technique for the preparation of barrier pigments that significantly mitigate the permeation of oxygen, water vapor, and hydrogen through polymer films containing these ...
Joshua Lommes   +4 more
wiley   +1 more source

On the Impact Energy Absorption of an Advanced High‐Strength Bilayer Steel Composite Consisting of Carbide‐Free Bainitic Steel and High‐Mn Twinning‐Induced Plasticity Steel

open access: yesAdvanced Engineering Materials, EarlyView.
Excellent combinations of strength and impact toughness are obtained in a bilayer composite of high‐strength carbide‐free bainitic (CFB) steel and high‐ductility twinning‐induced plasticity (TWIP) steel. The composite absorbs energy at small strains when the notch is placed on the TWIP side and at high strains when the notch is placed on the CFB side ...
Kendra Hawke   +5 more
wiley   +1 more source

Automatic Deployment Solution for Internet Business Platform Based on Open-Source PaaS

open access: yesDianxin kexue, 2015
Starting with the deployment architecture and deployment requirements of internet business platform in cloud environments,the deployment solution of the rising up open-source PaaS platform was analyzed,such as Docker and Cloudify.An open-source based ...
Zhenwei He   +4 more
doaj   +2 more sources

Home - About - Disclaimer - Privacy