Results 31 to 40 of about 6,281 (245)
Automatic control system of top coal caving on fully-mechanized coal mining face
Gong-kuang zidonghua, 2015 In view of problems of large randomness, low efficiency of coal caving of artificial operation for top coal caving mining face, an automatic control system of top coal caving on fully-mechanized coal mining face was designed.
WEI Wenya
doaj +2 more sources
International Journal of Mining Science and Technology, 2015 Aimed at determining the appropriate caving–mining ratio for fully mechanized mining of 20 m thick coal seam, this research investigated the effects of caving–mining ratio on the flow fields of coal and waste rocks, amount of cyclically caved coal and ...
Ningbo Zhang, Changyou Liu, Mengsong Pei
doaj +3 more sources
Grouting failure mechanism and new pre-grouting reinforcement technology of narrow coal pillar in fully-mechanized caving gob-side entry. [PDF]
Sci RepWith the wide application of large machinery in coal mining, the influence of mine pressure is large and wide. Therefore, it is very important to retain and maintain the strength of coal pillars in the working face section.
Chen D +10 more
europepmc +2 more sources
Research on overburden structural characteristics and support adaptability in cooperative mining of sectional coal pillar and bottom coal seam [PDF]
Scientific ReportsIn the mining process of the II1 coal seam at Zhaogu No. 2 coal mine, a method of stratified mining is employed, leaving relatively wide coal pillars in sections.
Du Feng +6 more
doaj +2 more sources
Numerical and in-situ investigation on the ground behavior of the end roof in fully mechanized caving face [PDF]
E3S Web of Conferences, 2021 Fully mechanized top coal caving is a major high-yield and high-efficiency coal mining method for thick seam mining. At present, it is affected by the further popularization and application of fully mechanized caving mining because the recovery rate is ...
Zang Chuanwei +5 more
doaj +1 more source
Effect of Face Length in Initial Mining Stage of Fully Mechanized Top-coal Caving Face With Large Mining Height [PDF]
Geotechnical and Geological Engineering, 2021 Abstract Based on the field measurement of the end resistance of the support during the initial weighting of the basic roof and the macroscopic mine pressure behavior during the weighting period of 101,22211,103 and 301 fully mechanized caving face in Changchun Xing Coal Mine, the mine pressure law of the working face is summarized and compared,
Jianhang Wang +4 more
openaire +1 more source
Strata behavior and control strategy of backfilling collaborate with caving fully-mechanized mining [PDF]
Open Geosciences, 2020 Abstract This article analyzes the technical difficulties in full-section backfill mining and briefly introduces the technical principle and advantages of backfilling combined with caving fully mechanized mining (BCCFM). To reveal the strata behavior law of the BCCFM workface, this work establishes a three-dimensional numerical model and
Wei Yin +4 more
openaire +2 more sources
Meikuang Anquan, 2021 Aiming at the problem of over-limit gas in the return air corner of the “U” type downward ventilation fully mechanized caving face in Baode Coal Mine, the law of gas migration in the stope and goaf was studied. Using Fluent numerical simulation software
ZHANG Zenghui, XUE Yanping
doaj +1 more source
Meikuang Anquan, 2023 In recent years, most of the coal mines in Zhungeer Coalfield have entered the mining of the second main coal seams, such as 6#, 10# and 11#, with an average thickness of more than 10 m, so most of the coal mines use fully mechanized caving mining ...
Hua NAN, Zhuoying WANG
doaj +1 more source
Frontiers in Earth Science, 2023 In order to reveal the influence of air leakage on oxygen concentration in goafs of fully mechanized caving mining with a shallow buried and high mining height, the air leakage of No.122108 working face in Caojiatan coal mine in different seasons was ...
Xing-long Zhu, H. Wen
semanticscholar +1 more source