Results 91 to 100 of about 951,474 (203)
Abstract Purpose To evaluate the marginal gap of two‐piece polyetheretherketone (PEEK) abutments fabricated with different methods, before and after thermal cycling, while also focusing on their pull‐off bond strength. Materials and Methods A two‐piece abutment was virtually designed after digitizing a titanium‐base (Ti‐base) abutment.
Almira Ada Diken Türksayar +6 more
wiley +1 more source
Improving the filament weld-strength of Fused Filament Fabrication products through improved interdiffusion [PDF]
Fused Filament Fabrication (FFF) is a popular additive manufacturing technique where molten polymer filament is applied in a raster pattern, layer by layer, to obtain the work piece.
Herrmann, Denis +4 more
core +1 more source
Abstract Purpose To investigate the effect of surface treatment and fabrication techniques of high‐performance polymers on their shear bond strength (SBS) to grade IV titanium. Materials and Methods A total of 120 pre‐milled titanium abutments were sectioned.
Ahmet Serkan Küçükekenci +3 more
wiley +1 more source
Abstract Purpose The aim of this study was to investigate the impact of an increasing level of monomer contamination of isopropanol (isopropyl alcohol [IPA]) during post‐rinsing on the dimensional stability of test samples produced by vat photopolymerization.
Florian Flierl +5 more
wiley +1 more source
Direct rheological characterization of polymer and polymer composite filament used in fused filament fabrication additive manufacturing. [PDF]
Understanding the behavior of polymer melt flows is important for predicting final part quality and improve processing performance, particularly in Fused Filament Fabrication (FFF) Additive Manufacturing (AM). There are limited resources available to the
Chen, Jingdong, 1992-
core
Advances in 3D‐Printed Scaffolds for Regenerative Therapy
This graphical abstract illustrates how coordinated decisions in biomaterial selection, printing strategy, structural design, biological functionalization, and performance tuning shape 3D‐printed regenerative scaffolds for tissue‐specific applications and their translation toward personalized regenerative therapy.
Shitang Song +5 more
wiley +1 more source
Three-dimensional printing/additive manufacturing (3DP/AM) for tissue engineering and regenerative medicine (TE/RM) applications is a multifaceted research area encompassing biology, material science, engineering, and the clinical sciences.
Nathan Castro +5 more
core +1 more source
Simulation of Locally Varying Residual Strains in 4D Printing
ABSTRACT Shape memory polymers (SMPs) are a class of materials capable of storing deformation in a programmed shape, which can be recovered when an external trigger, such as temperature, a magnetic field, or similar is applied. In the classical shape memory cycle, programming consists of successive heating, deformation and cooling steps. In combination
Henrik Hembrock +6 more
wiley +1 more source
The purpose for this study is to obtain a new composite manufacturing system based on Additive Manufacturing techniques that allows the creation of parts for the medical industry. These pieces will be resistant, lightweight and may have geometries more complex than those created with traditional systems of composite material. The new system is based on
Alberto Sánchez Ramírez +4 more
openaire +3 more sources
The fabrication of radio frequency (RF) devices using various 3D printing technologies has gained significant momentum. Among these, Fused Filament Fabrication (FFF) stands out as a cost-effective method, yet its potential for RF applications remains ...
Feng Zhang +8 more
doaj +1 more source

