Results 61 to 70 of about 285,159 (266)
A study of gas lift on oil/water flow in vertical risers [PDF]
, 2014 Gas lift is a means of enhancing oil recovery from hydrocarbon reservoirs. Gas injected at the production riser base reduces the gravity component of the pressure drop and thereby, increases the supply of oil from the reservoir. Also, gas injection at
Brini Ahmed, Salem Kalifa
core
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
Prediction of two-phase flow through a safety relief valve
, 2013 Safety relief valves are necessary elements in any pressurised system. The flow inside the safety relief valve shows a number of interesting, yet complicated, features especially when a two-phase flow is involved.
Elmayyah, Wael, Dempster, William
core +1 more source
Prediction of pressure drop in multiphase horizontal pipe flow [PDF]
, 2006 Empirical correlations were tested against reliable two phase pipe flow data for the prediction of pressure drop. Correlations are recommended for the prediction with stratified and annular type flows.
Spedding, P. L. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Two-phase discharge flow prediction in safety valves
, 2012 Safety Relief Valves (SRV) are necessary elements in the protection of any pressurised system and the prediction of the expected discharge flows is an important consideration for the valve sizing to ensure that rupture pressures do not occur.
Elmayyah, Wael, Dempster, William
core +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Advanced Engineering Materials, EarlyView.Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Computation, 2017 A novel computational fluid dynamics-population balance model (CFD-PBM) for the simulation of gas mixing in activated sludge (i.e., an opaque non-Newtonian liquid) in a bubble column is developed and described to solve the problem of measuring the ...
Le Wang +3 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim +2 more
wiley +1 more source
Flow dynamics characteristics of cleaning aircraft engine compressor blades using air-water mist flow [PDF]
AIP AdvancesThe deposition of dust particles on the surface of compressor blades can degrade the performance and reliability of aircraft engines. On-wing engine cleaning is an effective method to restore engine efficiency.
Jinjian Huo +3 more
doaj +1 more source