Results 21 to 30 of about 836,304 (292)
Heat diffusion in the disordered electron gas [PDF]
We study the thermal conductivity of the disordered two-dimensional electron gas. To this end we analyze the heat density-heat density correlation function concentrating on the scattering processes induced by the Coulomb interaction in the sub ...
Finkel'stein, A. M., Schwiete, G.
core +3 more sources
Highly Sensitive Photoacoustic Microcavity Gas Sensor for Leak Detection
A highly sensitive photoacoustic (PA) microcavity gas sensor for leak detection is proposed. The miniature and low-cost gas sensor mainly consisted of a micro-electro-mechanical system (MEMS) microphone and a stainless-steel capillary with two small ...
Ke Chen +9 more
doaj +1 more source
Investigation of the Shadow Effect in Focused Ion Beam Induced Deposition
Due to the precursor gas flow in the focused ion beam induced deposition process, a shadow effect appears behind the shading structures. This article carries out experiments with phenanthrene as the precursor gas and establishes a numerical model to ...
Chen Fang, Yan Xing
doaj +1 more source
Analytical modelling of stable isotope fractionation of volatile organic compounds in the unsaturated zone [PDF]
Analytical models were developed that simulate stable isotope ratios of volatile organic compounds (VOCs) near a point source contamination in the unsaturated zone. The models describe diffusive transport of VOCs, biodegradation and source ageing.
Abriola +52 more
core +3 more sources
Permeation of CO₂ and N₂ through glassy poly(dimethyl phenylene) oxide under steady- and presteady-state conditions [PDF]
Glassy polymers are often used for gas separations because of their high selectivity. Although the dual‐mode permeation model correctly fits their sorption and permeation isotherms, its physical interpretation is disputed, and it does not describe ...
Brooks, Daniel J. +9 more
core +4 more sources
FLATTENING OF A SCRATCH ON SINGLE CRYSTAL ICE SURFACE
The surface of a monocrystalline ice sample was observed at−5◦C (268 K). For which it was superficially polished and allowed to evolve in the presence of activated silica gel for three hours.
G. Aguirre Varela +3 more
doaj +1 more source
Hot-pressing is one of the most important stages in fabrication of the membrane electrode assembly in a single cell of proton exchange membrane fuel cells (PEMFCs).
Fu-Pin Ting +4 more
doaj +1 more source
When the ambient is rapidly decompressed, the gas dissolved in the rubber cannot be released quickly and expand, causing the rubber to bulge or even rupture, resulting in seal failure.
Chen Mingzhan +3 more
doaj
About Gas Permeability and Diffusion through Concrete
Gas production is expected in radioactive-waste storage structures. This will induce a slow increase in gas pressure, which necessitates the study of gas transfer at a low pressure. In this special case, calculations of the flow through storing materials
Takwa Lamouchi +4 more
doaj +1 more source
The effects of water and microstructure on the performance of polymer electrolyte fuel cells [PDF]
n this paper, we present a comprehensive non-isothermal, one-dimensional model of the cathode side of a Polymer Electrolyte Fuel Cell. We explicitly include the catalyst layer, gas diffusion layer and the membrane.
A. Young +59 more
core +1 more source

