Results 1 to 10 of about 63,965 (188)
Repairing of an Engine Block Through the Cold Gas Dynamic Spray Technology [PDF]
Materials Research, 2016 In the modern automotive industry, the maintenance of the vehicle during its life cycle is increasing in importance due to both economical and environmental considerations.
Antonello Astarita +2 more
doaj +5 more sources
SIMULATION OF TWO-PHASE FLOW IN COLD GAS-DYNAMIC SPRAYING
Авіаційно-космічна техніка та технологія, 2020 The one-dimensional gas-dynamic model for calculation of acceleration and heating of particles which takes into account space from the nozzle outlet to the substrate has been improved.
Андрій Олегович Волков +3 more
doaj +2 more sources
Mechanism of the powder material particle in different phase states—solid substrate interaction [PDF]
MATEC Web of Conferences, 2022 The paper discusses impact of solid and molten particles of a powder material in heterogeneous flow acting on solid surface and its effect on characteristics of coating applied by a gas-dynamic (cold spray) method. An equation of energy balance in impact
Borisov Sergey +4 more
doaj +1 more source
Materials & Design, 2021 The low temperature solid deposition characteristics of cold spraying technology are conducive to the remanufacturing/repair of oxidation sensitive titanium alloy in the atmosphere.
Lijing Yang +6 more
doaj +1 more source
Improving the Usage Properties of Steel Using Cold Spray Deposition: A Review
Crystals, 2023 In this paper, the improvement of the characteristics of different steels that are subjected to extreme operating conditions, including the steels used in the manufacture of various military components, the AISI 52100, the manufacture of bearings, and ...
Fabian Cezar Lupu +4 more
doaj +1 more source
Journal of the Mechanical Behavior of Materials, 2022 Cold spray process (CSP) is a thermal spray technology in which coating (10–40 µm) is formed in the solid state by the impingement of power particles with supersonic velocity (200–1,200 m/s2) on coupon employing compressed gas jet, below the melting ...
Ashokkumar Mohankumar +5 more
doaj +1 more source
Characterization by Dynamic Indentation on Laser-treated WC-Ti Coatings Deposited via Cold Gas Spray
Chemical Engineering Transactions, 2023 The present work is focused on the characterization of WC-Ti coatings via dynamic indentation, by which the elastic modulus and hardness were evaluated.The coatings were obtained by Cold Gas Spray (CGS) and then post-treated with a diode laser, to ...
Lidia Baiamonte +5 more
doaj +1 more source
Manufacturing Review, 2020 The techniques of cold gas dynamic spray (CGDS) coating involve the deposition of solid, high speed micron to nano particles onto a substrate. In contrast to a thermal spray, CGDS does not melt particles to retain their physico-chemical properties. There
Oyinbo Sunday Temitope, Jen Tien-Chien
doaj +1 more source
An Attempt to Understand Stainless 316 Powders for Cold-Spray Deposition
Powders, 2023 Cold gas dynamic spray (CS) is a unique technique for depositing material using high-strain-rate solid-state deformation. A major challenge for this technique is its dependence on the powder’s properties, and another is the lack of standards for ...
Neeraj S. Karmarkar +3 more
doaj +1 more source
Nanomechanical Characterization for Cold Spray: From Feedstock to Consolidated Material Properties
Metals, 2020 Cold gas-dynamic spray is a solid-state materials consolidation technology that has experienced successful adoption within the coatings, remanufacturing and repair sectors of the advanced manufacturing community.
Bryer C. Sousa +5 more
doaj +1 more source