Results 51 to 60 of about 16,511 (258)
The gas-lift method is crucial for maintaining oil production, particularly from an established field when the natural energy of the reservoirs is depleted.
Saad Hazem O. Al-Mansory +2 more
doaj +1 more source
Gas-lift technique is part of a long-term production sustainability solution in oil fields amid increasing water cuts and depleting reservoir energy.
Mahmudi M., Taghi Sadeghi M.
doaj +1 more source
Time‐Dependent Oxidation and Scale Evolution of a Wrought Co/Ni‐Based Superalloy
This study shows how a new wrought Co/Ni‐based superalloy resists oxidation at 800 ∘$^\circ$C. The oxide scale changes from rough, fast‐growing spinel to a dense, protective chromia–alumina layer. Atom probe analysis reveals tiny refractory‐rich bubbles at the interface that mark the transition to long‐term, diffusion‐controlled protection ...
Cameron Crabb +6 more
wiley +1 more source
Prediction of Hydrogel Degradation Time Based on Central Composite Design
Ying Wang +5 more
doaj +1 more source
Gas-lift reverse circulation drilling technology is one of the typical “bottom-hole negative pressure” drilling technologies. This technology can significantly reduce wellbore circulation pressure loss, alleviate the bottom-hole pressure holding effect ...
Pu Liu +4 more
doaj +1 more source
Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak +3 more
wiley +1 more source
Research on Integrated String for Gas Lift and Water Injection in HTHP and Sour Content Wells
In order to realize full production of crude oil in some oil wells with high gas-oil ratio in Tazhong Oilfield in Tarim Basin, an integrated string for gas lift and water injection has been designed.
Chen Defei +5 more
doaj
Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang +10 more
wiley +1 more source
Influence of Tubing Size and Gas Injection Method on Intermittent Gas lift
Intermittent gas lift can effectively improve the recovery efficiency of low-permeability, low-pressure and low-yield oil wells. In order to improve the lifting performance of intermittent gas lift, taking the VOF model as the theoretical basis, the ...
Yi Xianzhong +4 more
doaj

