Results 71 to 80 of about 3,338,670 (410)
Wall Temperature Measurements in Gas Turbine Combustors With Thermographic Phosphors
Journal of Engineering For Gas Turbines and Power, 2018 Phosphor thermometry has been developed for wall temperature measurements in gas turbines and gas turbine model combustors. An array of phosphors has been examined in detail for spatially and temporally resolved surface temperature measurements.
P. Nau, Z. Yin, O. Lammel, W. Meier
semanticscholar +1 more source
Advanced Science, EarlyView.This review highlights the latest advances in electrocatalytic nitrate reduction to ammonia, with a focus on catalyst design strategies, electrolyte engineering, and performance evaluation. Abstract The electrochemical reduction of nitrate for ammonia production not only offers a promising alternative to the traditional Haber–Bosch process, which ...
Juan Bai +8 more
wiley +1 more source
南方能源建设[Introduction] The gas turbine generator set (GE-PG9351FA) with a DLN2.0 + burner and a designed NOx emission concentration of 50 mg/m3 is used in a gas turbine power plant.
Shikai ZHANG +5 more
doaj +1 more source
Fuels research: Combustion effects overview [PDF]
, 1980 The effects of broadened property fuels on gas turbine combustors were assessed. Those physical and chemical properties of fuels that affect aviation gas turbine combustion were isolated and identified.
Haggard, J. B., Jr.
core +1 more source
Using Active Learning and Team Competition to Teach Gas Turbine Cycle Design [PDF]
, 2019 An elective, Analysis and Design of Propulsion Systems, has been a traditional lecture course teaching gas turbine engines from a design perspective.
Van Treuren, Kenneth
core +1 more source
Study On Gas Turbine Fault Simulation Of Marine Gas Turbine
, 2018 Gas turbine engine always runs at poor and changeable working conditions, its gas path components are extremely prone to failure, affecting the economy and safety of the gas turbine. In order to determine the type of gas path fault, the actual performance parameters of the components are required when gas path faults occur, which cannot be measured ...
Wang, Zhitao, Li, Jian, Liu, Rui
openaire +2 more sources
The Orlando Gas Turbines [PDF]
ASME 1961 Gas Turbine Power Conference and Exhibit, 1961 In 1958, The Orlando Utilities Commission installed two gas turbines for peaking and standby service. These units were then the largest simple-cycle gas turbines in the United States and among the largest anywhere, Fig. 1. The operating and maintenance experience with these units should be of interest to other users and potential users of large simple ...
C. H. Stanton, H. C. Luff
openaire +2 more sources
Advanced Science, EarlyView.In this study, the utilization of 3D printing driven by laser‐induced graphene and a conventional infiltration process for assembling kinds of graphene‐based polymer composites is described. The synergistic integration of polymers and the interconnected 3D‐LIG frameworks has endowed the composites with remarkable mechanical, electrical, and tunable ...
Fu Liu +6 more
wiley +1 more source
New nickel-base wrought superalloy with applications up to 1253 K (1800 F) [PDF]
, 1974 Alloy possesses combination of high tensile strength at low and intermediate temperatures to 1033 K with good rupture strength at high temperatures to 1255 K.
Black, H. L. +4 more
core +1 more source
Aircraft Gas Turbine Engine Health Monitoring System by Real Flight Data
, 2018 Modern condition monitoring-based methods are used to reduce maintenance costs, increase aircraft safety, and reduce fuel consumption. In the literature, parameters such as engine fan speeds, vibration, oil pressure, oil temperature, exhaust gas ...
Mustagime Tulin Yildirim, Bulent Kurt
semanticscholar +1 more source