Results 1 to 10 of about 2,490 (219)
Operating Gas Turbines in a Gas Processing Plant [PDF]
ASME 1967 Gas Turbine Conference and Products Show, 1967 In their gas processing plant on the Texas Gulf Coast the authors’ company recently converted from their original power source to two gas turbine units. This paper describes the equipment and reviews its installation, inlet and exhaust systems, maintenance, operation, and comparative cost.
Eugene B. Byrnes +2 more
openaire +1 more source
Topping the Groningen Steam Turbine Plant With a Gas Turbine [PDF]
Volume 4: Heat Transfer; Electric Power, 1987 Retrofitting existing steam turbine power plants with a gas turbine topping cycle can greatly enhance their efficiency to levels comparable with those of plants originally constructed as fully fired combined cycles. The economic benefits of this approach make it so attractive that utilities in the Netherlands are at present converting well over 3000 MW
J. J. Veenema +2 more
openaire +1 more source
NARX models of an industrial power plant gas turbine [PDF]
IEEE Transactions on Control Systems Technology, 2005 This brief reports the experience with the identification of a nonlinear autoregressive with exogenous inputs (NARX) model for the PGT10B1 power plant gas turbine manufactured by General Electric-Nuovo Pignone. Two operating conditions of the turbine are considered: isolated mode and nonisolated mode. The NARX model parameters are estimated iteratively
Michele Basso +3 more
openaire +1 more source
Exergetic analysis of gas turbine plants [PDF]
International Journal of Exergy, 2005 An exergetic analysis was performed for a 116-MW gas-turbine power plant. Mass and energy conservation laws were applied to each component of the system. Quantitative exergy balance for each component and for the whole system was considered. In this study, the exergy of a material stream is decomposed into thermal, mechanical and chemical exergy and an
Mohamad Javad Ebadi, Mofid Gorji-Bandpy
openaire +1 more source
PREDICTIVE REGULATORS FOR GAS TURBINE PLANTS
Modern Technologies and Scientific and Technological Progress, 2021 The efficient operation of gas turbine units (GTU) in isolated power supply systems with variable load is impossible without the presence of coordinatedly tuned automatic regulators, the adjustment of which requires calculations using complex algorithms.
Zyuy Chan, Van Nguen
openaire +2 more sources
Performance of a Gas Turbine Power Plant [PDF]
International Journal of Mechanical Engineering and Applications, 2017 Population of the world is increasing and so the demand of energy for domestic and industrial use. Worldwide efforts are being meet to produce energy from renewable resources but it is impossible to replace the fossil fuel resource of energy. Gas turbine remains the main energy converter of fossil fuel both for its liquid and gaseous states. This paper
openaire +1 more source
PERFORMANCE ANALYSES OF GAS TURBINE COGENERATION PLANTS
, 2017 In this study, some improving methods of gas turbine cogeneration cycles are applied on a simple cogeneration cycle. These methods are preheating air, preheating air and fuel, inlet air cooling by using evaporative cooling and absorption cooling. These cogeneration systems are evaluated with respect to energy efficiency (energy utilization factor ...
Karaali R., Oztürk I.T.
openaire +4 more sources
Gas Turbine and Steam Turbine Combined Generating Plants in Japan [PDF]
ASME 1971 International Gas Turbine Conference and Products Show, 1971 In these days, there has been a progressive increase in the application of gas turbines to the industrial field in Japan. Based on favorable reliability, the increasing demands of electric power have created the high capacity of gas and steam turbine combined plants.
Sooji Ujita, Harumi Hirai
openaire +1 more source
Improving The Performance Of Gas Turbine Power Plant By Modified Axial Turbine
, 2018 Computer-based optimization techniques can be employed to improve the efficiency of energy conversions processes, including reducing the aerodynamic loss in a thermal power plant turbomachine. In this paper, towards mitigating secondary flow losses, a design optimization workflow is implemented for the casing geometry of a 1.5 stage axial flow turbine ...
Rona, Aldo +3 more
openaire +2 more sources
IOP Conference Series: Materials Science and Engineering, 2019 Abstract We present a schematic diagram and the results of calculations of operating modes of the combined-cycle gas turbine plant (CCGTP) with a parallel superimposed gas-turbine plant (GTP). It is shown that at part-load operation in order to increase the efficiency of the unit, it is advisable to alter the steam turbine power while ...
V Fomin, A Kalyutik
openaire +1 more source