Results 21 to 30 of about 4,620 (258)
Design optimization of the suspension unit of the liner in the combustion chamber housing [PDF]
E3S Web of Conferences, 2023 The design of the suspension unit of the flame tube in the housing of the annular combustion chamber of a ground-based gas turbine installation of a gas pumping unit is given for placing it in a device for fixing the flame tube in the combustion chamber ...
Velikanov Peter +3 more
doaj +1 more source
Авіаційно-космічна техніка та технологія, 2018 The processes of gas turbine unit inlet air cooling by absorption lithium-bromide chiller utilizing the turbine exhaust gas waste heat as athermotransformer has been analyzed for hour-by-hour changing ambient air temperatures and changeable heat loads on
Андрій Миколайович Радченко +4 more
doaj +1 more source
Авіаційно-космічна техніка та технологія, 2017 Cooling the air at the inlet of gas turbine units by utilizing the exhaust gas waste heat in the combined absorption-ejector chiller with absorption lithium-bromide chiller as a gas turbine unit and refrigerant ejector chiller as a low temperature ...
Андрей Николаевич Радченко
doaj +1 more source
Gas Turbine Compressor Unit Repowering [PDF]
Volume 2: Design, Construction, and Operation Innovations; Compression and Pump Technology; SCADA, Automation, and Measurement; System Simulation; Geotechnical and Environmental, 1996 This paper presents how a major U.S. gas transmission and storage company restored gas storage peaking capacity by repowering obsolete gas turbine compressor units. Consumers Power Company’s Ray Field located in Macomb County, Michigan, USA, was developed as a 44 BCF working capacity gas storage field in 1966.
openaire +1 more source
Development of an exhaust air turbine engine
Вестник Самарского университета: Аэрокосмическая техника, технологии и машиностроение, 2016 The article discusses ways of utilizing exhaust gas heat to improve the power efficiency of heat engines. The concept of an air turbine engine is chosen to make a generator drive with the capacity of 150 kW intended to produce energy for a gas-pumping ...
Yu. S. Yeliseev +4 more
doaj +1 more source
Design Analysis of Micro Gas Turbines in Closed Cycles
Energies, 2020 The problems faced by designers of micro-turbines are connected with a very small volume flow rate of working media which leads to small blade heights and a high rotor speed.
Krzysztof Kosowski, Marian Piwowarski
doaj +1 more source
Авіаційно-космічна техніка та технологія, 2018 The processes of gas turbine unit two-stage intake air cooling by absorption lithium-bromide chiller as a high temperature cooling stage to the temperature of about 15 °C and by refrigerant ejector chiller as a low temperature cooling stage to the ...
Андрій Миколайович Радченко +3 more
doaj +1 more source
Polish Maritime Research, 2022 A thermal diagram of the combined gas-steam turbine unit of a hybrid cycle, which is an energy complex consisting of a base gas turbine engine with a steam turbine heat recovery circuit and a steam-injected gas turbine operating with overexpansion, is ...
Serbin Serhiy +3 more
doaj +1 more source
Comparison of Characteristics of SCR-DeNOx Catalyst for Gas-Turbine Units and Coal-Fired Units
Zhongguo dianli, 2021 Based on the comparison between gas-turbine units and coal-fired units in terms of the NOx emission policy requirements and the characteristics of catalysts in SCR process, this paper expounds the importance of SCR-DeNOx application in gas turbine units ...
Zhitan LIU +4 more
doaj +1 more source
A Mini-Packaged Gas Turbine Cogeneration Unit [PDF]
Volume 4: Heat Transfer; Electric Power; Industrial and Cogeneration, 1989 The cogeneration process is the simultaneous production of electrical (or mechanical) power and heat, where the latter is a by-product of the power release process. In this investigation a mini-packaged gas turbine cogeneration unit is proposed for commercial and small industrial sectors.
Ramiz Babus’Haq +2 more
openaire +1 more source