Results 51 to 60 of about 249,352 (290)

Challenges in the Development of Micro Gas Turbines for Concentrated Solar Power Systems [PDF]

open access: yes, 2016
Parabolic solar dish systems have gained more interest recently as a reliable way for harnessing the solar power in form of electricity. Micro gas turbines can be usedas engines in such system to convert the heat available from the solar
Al Zaili, J., Sayma, A. I.
core  

Satellite Thermal Management Pump Impeller Design and Optimization

open access: yesInventions
This study presents a numerical approach to the design and optimization of centrifugal impellers used in the pumps of active thermal control systems of spacecraft.
Valeriu Drăgan   +3 more
doaj   +1 more source

Operation regimes in a rotating detonation combustor [PDF]

open access: yesINCAS Bulletin
This paper presents an exploration of the operational envelope of a Rotating Detonation Combustor based on the design of the research group at the University of Southampton.
George Ionut VRABIE   +5 more
doaj   +1 more source

Experimental Analysis on the Operating Line of Two Gas Turbine Engines by Testing with Different Exhaust Nozzle Geometries

open access: yesEnergies, 2023
This paper presents a special analysis study about the gas turbine operating line, and an overall description of a gas turbines project, based on experimental data from two particular applications, in order to convert two different types of aero engines ...
Razvan Marius Catana   +1 more
doaj   +1 more source

Study On Gas Turbine Fault Simulation Of Marine Gas Turbine

open access: yes, 2018
Gas turbine engine always runs at poor and changeable working conditions, its gas path components are extremely prone to failure, affecting the economy and safety of the gas turbine. In order to determine the type of gas path fault, the actual performance parameters of the components are required when gas path faults occur, which cannot be measured ...
Wang, Zhitao, Li, Jian, Liu, Rui
openaire   +2 more sources

CONTRIBUTIONS TO CONSOLE PROGRAMMING OF A ROBOTIC SYSTEM FOR WELDING AN OVERSIZED HEAT EXCHANGER

open access: yesNonconventional Technologies Review, 2022
This paper first proposes to define the welding parameters of the GTAW (TIG/WIG) heat exchanger for a robotic system. The paper describes the first process of welding performed on the heat exchanger assembly, named pilot. An analysis will go through all
Andrei Mitru   +4 more
doaj  

Emissions control for ground power gas turbines [PDF]

open access: yes, 1977
The similarities and differences of emissions reduction technology for aircraft and ground power gas turbines is described. The capability of this technology to reduce ground power emissions to meet existing and proposed emissions standards is presented ...
Anderson, D. N.   +5 more
core   +1 more source

Acoustic Analysis of a Hybrid Propulsion System for Drone Applications

open access: yesAcoustics
This paper aims to conduct an acoustic analysis through noise measurements of a hybrid propulsion system intended for implementation on a drone, from which the main noise sources can be identified for further research on noise reduction techniques ...
Mădălin Dombrovschi   +6 more
doaj   +1 more source

Application of Neural Network in the Prediction of NOx Emissions from Degrading Gas Turbine [PDF]

open access: yesarXiv, 2022
This paper is aiming to apply neural network algorithm for predicting the process response (NOx emissions) from degrading natural gas turbines. Nine different process variables, or predictors, are considered in the predictive modelling. It is found out that the model trained by neural network algorithm should use part of recent data in the training and
arxiv  

FORTRAN program for computing coordinates of circular-arc, single and tandem, turbine and compressor, blade sections on a plane [PDF]

open access: yes, 1972
Coordinates for circular arc blade section of aircraft high speed compressor gas turbines were computed using FORTRAN 4 program. Aerodynamic configurations studied include single segment airfoils, airfoils with slots, and mutiple segment tandem arranged ...
Crouse, J. E., Mcnally, W. D.
core   +1 more source

Home - About - Disclaimer - Privacy