Results 221 to 230 of about 183,387 (282)

Novel approximate solutions of the fractional form of graphene sheet thermophoretic motion model. [PDF]

open access: yesSci Rep
Abdel-Aty AH   +5 more
europepmc   +1 more source

From Waste to Value: Conversion of Calcium Sulfate to Vaterite via Carbon Capture and Storage

open access: yesAdvanced Functional Materials, EarlyView.
This study introduces a new concept for carbon management that relies on the carbonation of industrial gypsum waste and yields phase‐pure vaterite at ambient conditions without any additives. The obtained vaterite is further shown to be a reactive material that develops compressive strength in aqueous suspensions like conventional cements.
Carlos Pimentel   +4 more
wiley   +1 more source

Melt Grafting of Geometry‐Tailored Voltage Stabilizers for High‐Performance Polypropylene Insulation

open access: yesAdvanced Functional Materials, EarlyView.
A scalable one‐step melt grafting strategy is developed to enhance the dielectric properties of isotactic polypropylene by covalently incorporating thermally stable aromatic voltage stabilizers. This solvent‐free approach improves volume resistivity and DC breakdown strength through deep trap formation and charge localization, offering a sustainable ...
Nazirul Mubin bin Normansah   +9 more
wiley   +1 more source

An Optimized Staining Method for Visualization of Thermally Denatured Dermal Collagen. [PDF]

open access: yesLasers Surg Med
Ahn GR   +6 more
europepmc   +1 more source

Multilayer Soft Photonic Arrays Inspired by Cephalopod Skin for High‐Density, Independent, and Multimodal Actuation

open access: yesAdvanced Functional Materials, EarlyView.
A vertically stacked, DEA‐driven photonic array inspired by cephalopod skin, featuring highly crystalline colloidal crystal gels with vivid color, low FWHM and scalability is presented. The multilayer design removes lateral pixel interference, achieving near‐100% fill factor with fully independent RGB actuation.
Maga Kim   +11 more
wiley   +1 more source

Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting

open access: yesAdvanced Functional Materials, EarlyView.
A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy