Enabling Smart Manufacturing Research and Development using a Product Lifecycle Test Bed. [PDF]
Procedia Manuf, 2015 Helu M, Hedberg T.
europepmc +1 more source
Promoting Model-based Definition to Establish a Complete Product Definition. [PDF]
J Manuf Sci Eng, 2017 Ruemler SP +4 more
europepmc +1 more source
Simultaneous head-mounted imaging of neural and hemodynamic activities at high spatiotemporal resolution in freely behaving mice. [PDF]
Sci AdvChen N +20 more
europepmc +1 more source
Evaluation of the marginal and internal gaps of three different dental prostheses: comparison of the silicone replica technique and three-dimensional superimposition analysis. [PDF]
J Adv Prosthodont, 2017 Park JY +5 more
europepmc +1 more source
Analyzing environmental sustainability methods for use earlier in the product lifecycle. [PDF]
J Clean Prod, 2018 Brundage MP +6 more
europepmc +1 more source
Characterization of Probe Dynamic Behaviors in Critical Dimension Atomic Force Microscopy. [PDF]
J Res Natl Inst Stand Technol, 2009 Feng SC, Joung CB, Vorburger TV.
europepmc +1 more source
On architecting and composing engineering information services to enable smart manufacturing. [PDF]
J Comput Inf Sci Eng, 2016 Kulvatunyou BS, Ivezic N, Srinivasan V.
europepmc +1 more source
Sensor Prototype to Evaluate the Contact Force in Measuring with Coordinate Measuring Arms. [PDF]
Sensors (Basel), 2015 Cuesta E +4 more
europepmc +1 more source
Application of geometric dimensioning and tolerancing to connector design
, 2000 Even though Geometric Dimensioning and Tolerancing (GDT) is a good drawing specification tool, widely accepted and used in most industries, there are needs to improve on its usage. This dissertation explores the important reasons behind GDT usage, specifically to the connector industry.
openaire +1 more source
An Additive Manufacturing Test Artifact. [PDF]
J Res Natl Inst Stand Technol, 2014 Moylan S +4 more
europepmc +1 more source