Results 101 to 110 of about 2,373,608 (351)
Compressive strength of concrete using glass powder as a filler replacement [PDF]
, 2012 A lot of researches have been done to improve the quality of concrete that can be used in long term period and design a more economic concrete for the construction. Using waste glass as a construction material is a good way to help the environment.
Nur Shahira Diana , Salehuddin
core
Environment Conservation JournalThis study examines the effects of recycled aggregate and waste glass powder on concrete's fresh and mechanical characteristics. This investigation used recycled aggregate and waste glass powder content of 0%, 10%, 20%, 30%, 40%, and 50% to partially ...
Umesh Jhakal, Sunil Thakur, Sumesh Jain
doaj +1 more source
Effect of glass powder on the compression strength and the workability of concrete
Cogent Engineering, 2017 Several studies have been made to examine the potential mineralogical and mechanical properties of glass aiming to improve the characteristic properties of concrete where glass has been used in various forms, powder form or fine and coarse aggregate form,
Afif Rahma +2 more
doaj +1 more source
Advanced Functional Materials, EarlyView.This study investigates H4TBAPy‐based metal–organic frameworks (MOFs) ‐ NU‐1000, NU‐901, SrTBAPy, and BaTBAPy ‐ for multiphoton absorption (MPA) performance. It observes topology‐dependent variations in the 2PA cross‐section, with BaTBAPy exhibiting the highest activity.
Simon N. Deger +10 more
wiley +1 more source
Silicon carbide fiber reinforced strontium aluminosilicate glass-ceramic matrix composite [PDF]
A SrO-Al2O3 - 2SrO2 (SAS) glass ceramic matrix is reinforced with CVD SiC continuous fibers. This material is prepared by casting a slurry of SAS glass powder into tapes.
Bansal, Narottam
core +1 more source
The spectroscopic detection of drugs of abuse in fingerprints after development with powders and recovery with adhesive lifters [PDF]
, 2009 The application of powders to fingerprints has long been established as an effective and reliable method for developing latent fingerprints. Fingerprints developed in situ at a crime scene routinely undergo lifting with specialist tapes and are then ...
Went, Michael J., West, M.J.
core +1 more source
Civil and Environmental EngineeringDue to its large activity and raw material use, construction offers great recycled material potential. Demolition and construction waste affect the cycle.
Taher Muntadher J. +2 more
doaj +1 more source
Compression Process of Spherical Glass Powders
Journal of the Japan Society of Powder and Powder Metallurgy, 1965 The compression of spherical glass powders has been studied by static method in the pressure range 0-7.5 tons per cm2 (Fig.1). The results obtained are as follows.(1) During the compression process, the following distinct steps are observed (Photo. 1, 2) : (a) Packing without crushing (Initial stage of Fig. 2, 5, 6).
Kimio Kawakita +4 more
openaire +2 more sources
Advanced Functional Materials, EarlyView.A combinatorial library of dual‐functional antiviral oligomers incorporating N‐halamine and quaternary ammonium functionalities is developed for long‐lasting antiviral activity. The lead materials exhibit rapid and durable antiviral activity against SARS‐CoV‐2 variants and influenza H1N1, with 4 to 5 log reduction in viral copies at 5 mg mL−1 ...
Eid Nassar‐Marjiya +14 more
wiley +1 more source
The stickiness curves of dairy powder : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Bioprocess Engineering at Massey University [PDF]
, 2004 Powder stickiness problems encountered during spray drying are important to the dairy industry. Instantaneous stickiness is a surface phenomena that is caused by exceeding the glass transition temperature of the amorphous sugar in the powder, usually ...
Zuo, Jenny Y
core