Results 141 to 150 of about 63,119 (309)
Development of an amperometric biosensor for the detection of alcohol: a thesis presented in partial fulfilment of the requirements for the degree of Masters in Science in Biochemistry at Massey University [PDF]
The aim of the following work was to design a biosensor for the detection of ethanol. A biosensor is an analytical device in which a biological sensing element is connected to or integrated with a physical transducing element.
Large, Ruth
core
The combination of formamidinium thiocyanate and 1,3‐propane diammonium iodide for bulk and top‐surface passivation, and a ternary fullerene blend to improve energy band alignment, suppresses energy losses in wide‐bandgap FAPbBr3 perovskite solar cells.
Laura Bellini +9 more
wiley +1 more source
Electroactive Liquid Crystal Elastomers as Soft Actuators
Electroactive liquid crystal elastomers (eLCEs) can be actuated via electromechanical, electrochemical, or electrothermal effects. a) Electromechanical effects include Maxwell stress, electrostriction, and the electroclinic effect. b) Electrochemical effects arise from electrode redox reactions.
Yakui Deng, Min‐Hui Li
wiley +1 more source
Catalytic Reduction of Bisulfite by Myoglobin/Surfactant Films [PDF]
The voltammetry of bisulfite at a film formed with myoglobin was studied in aqueous solutions. A broad wave was observed for the reduction of bisulfite.
Abdellatty, Radalla +2 more
core +1 more source
Fe─NC porous oxygen reduction electrocatalysts are prepared employing a 2,4,6‐Triaminopyrimidine‐based porous organic polymer, a Mg2+ Lewis acid, and a low‐temperature cation exchange protocol. Using the polymer precursor achieves high pyrolysis yields and results in atomically dispersed FeNx sites. The resulting catalysts feature hierarchical porosity
Eliot Petitdemange +11 more
wiley +1 more source
A graphene quantum dots-glassy carbon electrode-based electrochemical sensor for monitoring malathion. [PDF]
Tanwar S, Sharma A, Mathur D.
europepmc +1 more source
It is reported that the ferroelectric switching behavior of rhombohedral (3R) phase transition metal dichalcogenide (TMD) bilayers strongly depends on their domain structures. Single‐domain TMDs (SD‐TMDs) with domain‐wall‐free structures exhibit robust and stable polarization switching, whereas poly‐domain TMDs (PD‐TMDs) with randomly distributed ...
Ji‐Hwan Baek +8 more
wiley +1 more source
Na‐ion batteries ‐ Impact of doping on the oxygen redox: The sloping potential of NaMg0.1Ni0.4Mn0.5O2 above 4.0 V is caused by a new redox center (arising from the ‘O bound to Mg’), having a higher potential but being more irreversible compared to the ‘O bound to Ni’.
Yongchun Li +12 more
wiley +1 more source
A Route to Surface-bound Metalloporphyrins as Models for Oxygen Reduction Catalysts [PDF]
The attachment nonmetal and magnesium ethynyl terminated porphyrin (TEPP and MgTEPP) to glassy carbon electrode was achieved through voltammetry. These attached porphyrins were studied by cyclic voltammetry (CV) and UV-visible spectroscopy. Surface-bound
Van Wyck, Stephen J
core +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source

