Results 91 to 100 of about 5,034,128 (242)
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
2013 Delaware Division of Corporations Annual Report
Annual report for 2013 from the Delaware Division of ...
Division of Corporations
core +2 more sources
Gallium microalloying redirects interfacial reactions in low‐temperature Bi–Sn solders from Cu–Sn toward Cu–Ga intermetallic formation. The resulting Cu–Ga layer suppresses intermetallic growth during thermal aging, alters fracture pathways, and improves interfacial stability.
Iva Králová +6 more
wiley +1 more source
This article investigates the agency of the world’s largest food and agribusiness corporations in global water security via case studies of Nestlé, Bunge and Cargill by analysing their position in the political economy of the world agro-food system and ...
Suvi Sojamo, Elizabeth Archer Larson
doaj
The article examines the role and importance of transnational corporations in today’s global world economy, as well as their influence on the development of national economies.
doaj
Feasibility and Limitations of the Advanced Replica Process for Bioactive Glasses
Periodic 3D‐printed Kelvin‐cell templates enable a controlled advanced replica process for fabricating highly porous glass lattices. Across P45K9, 45S5, and 13–93, material‐dependent differences in coating, burnout, and shrinkage lead to distinct strut morphologies, while comparable final porosities of 83%–88% are retained.
Swantje Funk +4 more
wiley +1 more source
2015 Delaware Division of Corporations Annual Report
2015 Delaware Division of Corporations Annual ...
Division of Corporations
core +2 more sources
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe +6 more
wiley +1 more source
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
A multifunctional structural power composite is developed by integrating high‐mass‐loading Zn‐ion hybrid supercapacitors with metal mesh current collectors and aramid nanofiber‐based composite electrolytes, enabling simultaneous load‐bearing capability and enhanced areal energy storage.
Yuseung Choi +8 more
wiley +1 more source

