Results 281 to 290 of about 171,662 (340)
Some of the next articles are maybe not open access.

Synchronous Stability Analysis Model of Grid-following Converter Based on Singular Perturbation Method

2024 10th International Conference on Electrical Engineering, Control and Robotics (EECR)
As a high-order nonlinear system, the dynamic characteristics of the grid-following converter are complex and the PIs' parameters are difficult to configure.
Yiyuan Lu   +7 more
semanticscholar   +1 more source

PCC dq-Frame Based Power Loop Modeling and Stability Analysis of Grid-Following Converter

2024 CPSS & IEEE International Symposium on Energy Storage and Conversion (ISESC)
For large-scale renewable energy power generation plants, the impedance model based stability analysis method, which describes the dynamic characteristics between instantaneous voltage and current of the converter terminal, has the advantages of clear ...
Yihang Zhao   +4 more
semanticscholar   +1 more source

Multisampled current control of grid-following voltage source converters

Pulse width modulation (PWM)–based current control is widely used in grid-following voltage source converters (VSCs). However, a large control delay is induced in the regular PWM process, which limits the current control bandwidth and deteriorates VSC-grid interactive stability.
He, Shan; id_orcid 0000-0001-6789-8271   +1 more
openaire   +2 more sources

Impact of Grid Faults on Grid-Following Converter Controller Operation and Phase Instability

IEEE International Conference on Renewable Energy Research and Applications
Currently, most Inverter-Based Resources (IBRs) connected to power systems use Grid Following Inverter (GFL) models. However, as the penetration of IBRs in power systems increases, concerns about inverter control issues in weak grids are growing ...
Inchan Hong, Y. Yoo, Seungmin Jung
semanticscholar   +1 more source

Large-Signal Stability Analysis of Grid-Following Converters Considering the Behavior of Grid-Forming Converters

International Journal of Circuit Theory and Applications
ABSTRACTThe increasing penetration of renewable energy challenges single‐converter systems to simultaneously provide transient support and rapid response. Hybrid microgrids integrating grid‐forming (GFM) and grid‐following (GFL) converters are thus essential for dual‐high power systems.
Meng Huang   +4 more
openaire   +2 more sources

Passivity-Based Optimal State-Feedback Control for LCL-Filtered Grid-Following Converter

IEEE transactions on power electronics
As the grid incorporates more voltage-source converters (VSCs), the stability issues arising from VSC-grid interactions escalate. While passivity theory offers a promising solution, existing passivity-based controller designs primarily rely on heuristic ...
Chao Gao   +6 more
semanticscholar   +1 more source

Modeling and Control of Three-Phase Grid-Following Converter via Matlab/Simulink

2024 6th International Conference on Smart Power & Internet Energy Systems (SPIES)
The integration of renewable energy sources (RES) into modern power grids has necessitated the use of grid-following (GFL) converters to ensure reliable synchronization and power exchange between distributed energy resources (DERs) and the grid.
Qusay Salem   +5 more
semanticscholar   +1 more source

Transient Stability Analysis Between Grid-Following DFIG-WT and Grid-Forming Converter in Electromechanical Timescale

IEEE transactions on energy conversion
Due to the transient control switch, the electromechanical dynamic of grid-following-based doubly fed induction generator-based wind turbine (GFL-DFIG) would be excited and significantly interact with grid-forming-based voltage-source converter (GFM-VSC).
Wangqianyun Tang   +4 more
semanticscholar   +1 more source

Current Regulation of Grid-Following Converters with Low Carrier Ratio

2021 International Conference on Power System Technology (POWERCON), 2021
Lulu Huang, Bo Gao, Wenhe Li
openaire   +1 more source

Grid-Connected Converter With Grid-Forming and Grid-Following Modes Presenting Symmetrical and Asymmetrical Fault Ride-Through Capability

IEEE Journal of Emerging and Selected Topics in Power Electronics
Grid-connected converters must remain coupled to the grid during a fault. They have to control the reactive currents injected to the grid because of its limited overload capacity. In particular, grid-forming (GFM) converters ride through the fault either
Diego Ri-os-Castro   +2 more
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy