Results 61 to 70 of about 105,329 (265)
3D conductive frameworks can maintain continuous electron transport, mechanical stability, and interfacial integrity, helping next‐generation batteries operate more efficiently. This Review examines their relevance to Si anodes, all‐solid‐state batteries, and dry‐processed electrodes, and highlights bio‐derived carbons as sustainable, structurally ...
SeoYoung Ha +5 more
wiley +1 more source
This study investigates friction and wear of AISI 52100 steel under dry sliding in CO2, air, and N2 atmospheres, with and without contact electrification. CO2 forms a stable carbon‐rich tribofilm that reduces friction by ∼30% and wear by ∼85%. High‐resolution TEM, EELS, and molecular dynamics reveal pressure‐dependent lubrication mechanisms, showing ...
Julio A. Cao‐Romero‐Gallegos +6 more
wiley +1 more source
The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz +5 more
wiley +1 more source
Milled polycrystalline NMC811 cathode (MPC NMC) with smaller secondary particle and higher surface area had 1) greater cathode tortuosity, 2) reduced surface Ni on the cycled MPC cathodes consistent with surface reconstruction, and 3) increased Ni deposition from cathode‐anode crosstalk, manifesting in lower functional capacity and higher impedance ...
Edelmy J. Marin Bernardez +22 more
wiley +1 more source
Electric vehicle charging stations (EVCS) that are based on DC microgrids are presented in this research. The system comprises a solar photovoltaic system (SPVS), storage battery (SB), electric vehicle (EV) and grid.
Abhishek Pratap Singh +5 more
doaj +1 more source
Hierarchically microarchitected PLA/S/CNT cathodes are fabricated via scalable fused filament 3D printing as high‐sulfur‐loading hosts for rechargeable lithium–sulfur batteries. The assembled Li–S cells with sulfur loadings up to 17 mg cm−2 deliver an areal capacity of 9.2 mAh cm−2 and retain 96% of their discharge capacity after 100 charge–discharge ...
Vinay Gupta +4 more
wiley +1 more source
Analysis of a Single-Phase Z-Source Inverter for Battery Discharging in Vehicle to Grid Applications
Vehicle to Grid technology allows the batteries of electric vehicles to operate as energy storage elements for renewable energy power systems. The Z-Source inverter is a new and attractive topology for the power electronics interface.
Shumei Cui +4 more
doaj +1 more source
This review systematically explains the synthesis, properties, and energy storage and conversion applications of vanadium carbides. We introduce the structural and the synthetic strategies and reviewed recent developments in the material synthesis processes. The emerging applications of vanadium carbides in energy storage and conversion are highlighted.
Swathy B. Saseendran +2 more
wiley +1 more source
Machine Learning Enables Inverse Design of Optically Driven Microscopic Metavehicles
Machine‐learning‐based inverse design is used optimize “metavehicles” — flat microparticles based on metagratings that generate a strong lateral optical force from normally incident light. The optimized design exhibits a force efficiency of ∼88% and a measured propulsion speed in water much higher than previously reported, demonstrating that inverse ...
Vasilii Mylnikov +2 more
wiley +1 more source
To promote peer‐to‐peer trading in a distribution system with the franchise owned by the concerned distribution company respected, a so‐called “source‐grid‐load‐storage” (SGLS) integrated project is promoted in China.
Zihao Li +5 more
doaj +1 more source

