Results 121 to 130 of about 2,892,347 (284)

Effects of LLZO Microstructure Porosity, LLZO/Li‐Metal Interfacial Polarization Resistance, and Applied Areal Current Density on Li‐Metal Dendrite Formation in LLZO Bilayer Symmetric Cells

open access: yesAdvanced Functional Materials, EarlyView.
The effects of solid‐state electrolyte architecture and electrolyte/electrode interfacial polarization resistance on Critical Current Density and the risks for “interfacial” and “internal” Li‐metal dendrite formation were investigated in simulations of FIB‐reconstructed porous‐dense Li7La3Zr2O12 (LLZO) “bilayers”, providing insight for full cells ...
Tanner R. Hamann   +2 more
wiley   +1 more source

Amphoteric Cu‐Doping Leading to High Thermoelectric Performance in p‐Type Bismuth Antimony Telluride

open access: yesAdvanced Functional Materials, EarlyView.
This study shows that Cu plays two opposite roles in p‐type Bi0.5Sb1.5Te3 depending on the processing route. Under thermodynamic‐equilibrium bulk‐synthesis, Cu mainly occupies cation sites, increases hole concentration, preserves mobility, and slightly reduces lattice heat transport. The best‐performing composition among the investigated series reaches
Moritz Thiem   +15 more
wiley   +1 more source

Energy-Saving Effects of the Intermittent Control of Pumps in Ground Source Variable Refrigerant Flow Systems with a Buffer Water Tank

open access: yesEnergies
Variable refrigerant flow (VRF) systems are common air-conditioning systems used in regions with moderate climates that have cooling and heating demands.
Toya Tanaka   +3 more
doaj   +1 more source

Condensing Heat Exchangers Optimize Steam Boilers

open access: yes, 1983
The development of fluorocarbon resin covered tubes has advanced to the point where full scale marketing in connection with condensing heat exchangers has begun. Field installations show simple paybacks of one to one and a half years with resulting steam
Sullivan, B., Sullivan, P. A.
core  

Assessing the applicability of thermal response testing to energy piles

open access: yes, 2014
Deep foundations are increasingly being used, not just to carry structural loads, but also to act as heat exchangers as part of a ground source heat pump system.
Loveridge, F.A.   +3 more
core   +1 more source

Advancing Human Skin Equivalents: The Crucial Role of Neurovascular Integration

open access: yesAdvanced Healthcare Materials, EarlyView.
This review discusses the importance of integrating vascular and peripheral nerve systems into human skin equivalents (HSEs) to better recapitulate native skin physiology. Recent advances in vascularized, innervated, and neurovascularized HSEs are highlighted, together with emerging bioengineering strategies, current challenges, and future ...
Hao Wu   +4 more
wiley   +1 more source

Group thermal response testing for energy piles

open access: yes, 2015
Thermal response testing is an in situ technique for characterising the thermal conductivity of the ground around a borehole heat exchanger. The test has seen renewed interest in recent years as an increasing number of ground heat exchangers are being ...
Loveridge, F.A.   +3 more
core   +1 more source

Ground Heat Exchangers from Artificial Ground-Freezing Probes for Tunnel Excavations

open access: yesEnergies
Ground-source heat pumps (GSHPs), despite their high efficiencies, are still not as cost-effective as air-source heat pumps, especially in urban environments, due to the necessity of drilling/excavation.
Fawad Ahmed   +3 more
doaj   +1 more source

Magnetically Driven Biofabrication for Tissue Engineering: From Nanoparticle Design to Mag‐ATMP Translation

open access: yesAdvanced Healthcare Materials, EarlyView.
Magnetically responsive nanoparticles enable remote control over biomaterials, cells, and engineered tissues. This review summarizes material design, biological safety, fabrication and actuation strategies, computational validation, and translational pathways that support the development of magnetic tissue‐engineering platforms and future magnetically ...
Konstantinos Ioannidis   +8 more
wiley   +1 more source

Development of educational software for designing shell-and-tube heat exchangers [PDF]

open access: yes, 2011
A framework for developing educational software using the Visual Basic (VB) programming language for designing shell-and-tube heat exchangers (based on Kern and Bell-Delaware methods) is presented in this study.
Yin, C-Y, El-Harbawi, M., Acellam, D.
core  

Home - About - Disclaimer - Privacy