Results 171 to 180 of about 1,374,449 (283)

Study on the influence of near-fault vertical ground motion on the dynamic response of separation and collision of bridge. [PDF]

Sci Rep
Liu X, Li L, Liu Y, Chen S, An W.
europepmc   +1 more source

Manufacturing Continuous Fiber‐Reinforced Printing Filaments: Development of a Post‐Consolidation Unit

Advanced Engineering Materials, EarlyView.
A novel, temperature‐controlled post‐consolidation unit is developed to test its potential to improve the melt impregnation process used to manufacture continuous fiber‐reinforced filaments for additive manufacturing of high‐performance thermoplastics.
Daniel Beermann, Patrick Schiebel, David May   +2 more
wiley   +1 more source

Strong ground motion prediction model for EPA in Loess Plateau of Northwestern China. [PDF]

Sci Rep
Xi S, Li X, Wan W, Wang X, Wang H, Hu B.
europepmc   +1 more source

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

The Impact of Bedrock Material Conditions on the Seismic Behavior of an Earth Dam Using Experimentally Derived Spatiotemporal Parameters for Spatially Varying Ground Motion. [PDF]

Materials (Basel)
Boroń P, Dulińska JM.
europepmc   +1 more source

Inflammatory Response‐Inspired Thermochromic Shield for Pneumatic Structures

Advanced Engineering Materials, EarlyView.
A thermochromic shield for pneumatic structures is developed, using anhydrous sodium acetate powder and thermochromic pigment‐included solution. In this shield composed of three layers, the exothermic and thermochromic reactions, followed by the mixture of both components, occur promptly with an incident of penetrating damage as a sign of initial ...
Hyun Jae Lee, Ryuma Niiyama
wiley   +1 more source

Variabilities of ground motion in 2023 M_w 7.8 Pazarcık earthquake in Turkey and 2008 M_w 7.9 Wenchuan earthquake in China. [PDF]

Sci Rep
Xu P, Liu X, Li L.
europepmc   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Seismic scenario simulation and ANN-based ground motion model development on the North Tabriz Fault in Northwest Iran. [PDF]

J Seismol
Temiz C, Hussaini SMS, Karimzadeh S, Askan A, Lourenço PB.   +4 more
europepmc   +1 more source

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source